Contents
What is the output voltage of a comparator?
A comparator circuit compares two voltages and outputs either a 1 (the voltage at the plus side; VDD in the illustration) or a 0 (the voltage at the negative side) to indicate which is larger. Comparators are often used, for example, to check whether an input has reached some predetermined value.
At what below condition the output of op-amp will be undistorted?
Explanation: As long as the value of right hand side equation is less than the slew rate of op-amp, the output wave form will always be undistorted.
What should the reference voltage be for an op-amp comparator?
Comparator Reference Voltages In theory the comparators reference voltage can be set to be anywhere between 0v and the supply voltage but there are practical limitations on the actual voltage range depending on the op-amp comparator being device used. Positive and Negative Voltage Comparators
What happens to the op amp comparator when Vin is slow?
Op-amp Comparator with Positive Feedback. However if the input signal, VIN is slow to change or electrical noise is present, then the op-amp comparator may oscillate switching its output back and forth between the two saturation states, +Vcc and -Vcc as the input signal hovers around the reference voltage, VREF level.
How is the inverting comparator circuit connected to the operational amplifier?
Inverting Comparator Circuit In the inverting configuration, which is the opposite of the positive configuration above, the reference voltage is connected to the non-inverting input of the operational amplifier while the input signal is connected to the inverting input.
What is the output voltage of an operational amplifier?
We have also seen that the standard operational amplifier is characterised by its open-loop gain AO and that its output voltage is given by the expression: VOUT = AO(V+ – V-) where V+ and V- correspond to the voltages at the non-inverting and the inverting terminals respectively.