How is Gerber output generated in Altium Designer 21?

How is Gerber output generated in Altium Designer 21?

In an OutputJob Configuration file ( *.OutJob ). The output is generated when the configured output generator is run. In an active PCB document, click File » Fabrication Outputs » Gerber Files . The output will be generated immediately upon clicking OK in the dialog.

How to override default file name in Altium?

To override the default, click the Change link in the Output Containers region of the OutJob file to open the Folder Structure settings dialog. In the Output Options region in the Advanced section, enable the Use the Output Name as the file name instead of the default option.

Where are the settings stored in Gerber setup?

The settings defined in the Gerber Setup dialog when generating output directly from the PCB are distinct and separate to those defined for the same output type in an OutputJob Configuration file. In the case of the former, the settings are stored in the project file, whereas for the latter, they are stored in the OutputJob Configuration file.

How to export top layer Gerber to PCB?

Export TopLayer gerber into PCB document file Select Layer1.GTL tab in Altium Select the Menu → Tables → Layers Order option. Enable the Export to PCB option as follows: Menu → Tools → Netlist → Extract. Now, select Menu → File → Export → Export to PCB and a new PCB document will be opened with the Top Layer.

How is layer stack management performed in Altium?

All aspects of layer stack management are performed in the Layer Stack Manager. The default stackup for a new board is shown, the layer materials have been selected. As a standard document editor, the Layer Stack Manager (LSM) can be left open while the board is being worked on, allowing you to switch back and forth between the board and the LSM.

Where do you place drill slot in Altium Designer 21?

First, ensure that the layer you wish to place a drill slot on, is the active layer. This is achieved by double-clicking on the layer name in the layers list area of the CAMtastic panel.

How to rotate aperture wheel in Altium Designer 21?

Use the following options to choose the position on the film: Unsorted (raster) – select to use raster machine (default). Sorted (vector) – select to use vector machine. G54 on aperture change – check this option to rotate the aperture wheel of the plotter after each aperture change. Use software arcs – check this option to use software arcs.

Do you leave the part designator in Altium?

I want to keep the part outlines in Altium but hand off gerbers to the PCB fabricator that just have the component designator. Any ideas? Thanks for contributing an answer to Electrical Engineering Stack Exchange! Please be sure to answer the question. Provide details and share your research! But avoid …

How to remove component overlay but leave part designator?

Altium Remove Component Overlay but Leave Part Designator? I’m working on a board using someone elses footprint library for passives, and the part outlines for some reason are really close to the pads. I see how to use PCB list to hide part designators, but is there an easy way to hide the footprint outlines and keep the part designators?