How do you set trace width in Eagle?

How do you set trace width in Eagle?

These are my steps:

1. Install of the ULP with the command “run groupNet –install”.
2. Hover over the trace/net to select.
3. Right click on the trace/net.
4. Select “Group Net” in the context menu.
5. Type “change width” and choose whatever width.

How do I delete a route in Eagle?

Now in Autodesk EAGLE, if you find yourself with a trace segment that you want to remove, press the Backspace key while you’re routing and it’s gone.

How do you autoroute an eagle?

Select the Start button to begin the autorouting process. Autorouting on a low effort mode produced five potential routing variations that the autorouter will attempt. Once the routing is complete, select the Evaluate button, and you’ll see your completion percentage in the bottom-left corner of your interface.

How do you connect vias in Eagle?

To place a via mid-route, first left-click in the black ether between pins to “glue” your trace down. Then you can either change the layer manually in the options bar up top, or click your middle mouse button to swap sides. And continue routing to your destination. EAGLE will automatically add a via for you.

How do I disable layers in Eagle?

I’m using the Eagle 9.4. 2 Free version and in there, you can simply click on the “Layers” button to get a menu that displays the layers and you can simply click the “eye” icon to hide or show them.

What is an Airwire in EAGLE?

Zero length airwires If two or more wires of the same signal on different routing layers end at the same point without being connected through a pad or a via, a zero length airwire is generated, which will be displayed as an X-shaped cross in the Unrouted layer.

How do I set autoroute on my Eagle?

Changing the settings afterwards will not affect the already routed nets. It is time to use the autoroute function. Switch to board view and place your components on the board (if you haven’t already). Then choose “Auto…” from the “Tools” menu. A window with lots of different settings pops up.

Can you use autorouter on a complex board?

Your board is routed automatically. The autorouter is not very smart. With complex boards you cannot expect to just run the autorouter and get everything routed perfectly. But you can also combine the autoroute with manual routing. Post your questions and comments in the comment field below.

How to change NET classes in Eagle autorouter?

If you want to change to another net class, choose “Info” from the “View” menu. Select the net you want to change and at the bottom choose the net class you want for this net. Then click “Ok”. The net classes must be set before you route your board. Changing the settings afterwards will not affect the already routed nets.

When to use autorouter to optimize placement?

Optimizing Placement. After placing all of your components, you can then use the autorouter to see how optimized your components are placed. If the autorouter returns a completion result of 85% or greater than you know you did a good job of placing your parts. If not, consider pushing your parts around. Discovering Bottlenecks.