Contents
How to start OpenOCD with ft2232h adapter?
If we don’t, an error will appear: After you download a copy of OpenOCD as we described previously, run CMD console, then go to the directory where OpenOCD is present. For example: Remember: We have a configuration file (I named it SWD_FT.cfg) and the target is one of the EFM32 chips. Sudo openocd -f interface/ftdi/SWD_FT.cfg -f target/efm32.cfg
What does an adapter do for OpenOCD debugger?
The adapter is a hardware module that provides the right signals for the target to understand. OpenOCD debugger supports a lot of debugging adapters, which can be viewed on the OpenOCD website. To make OpenOCD work, you should configure it using commands or by using configuration files.
How to use a ft2232h as a SWD adapter?
Lastly, in order to use the FT2232H as a SWD adapter, you have to put a 470 OHM resistor between AD1 / AD2 on the FT2232H. Once we have the pins on the FT2232H hooked up to the target we can use the following script to query the DPIDR register on the DAP controller:
What kind of adapter do I need for OpenOCD?
We’ll use an FT2232H as the bridge to translate signals from the USB port to the SWD interface. Open On-Chip Debugger (OpenOCD) is a free, open-source project that aims to provide debugging, in-system programming, and boundary scan using a debug adapter.
What kind of data bus does FIFO use?
FIFO mode uses a byte wide data bus for high speed data transfer between a PC host and an FPGA or microcontroller. This document applies to the following FTDI devices: FT245B, FT245R, FT240X, FT2232D, FT232H, and FT2232H. All of these devices function as FIFO slaves.
How to connect SWDIO to TDI using ft2232h?
There is a configuration file called “swd-resistor-hack.cfg” that includes a wiring diagram: “Connect TDI to SWDIO via a suitable series resistor (220-470 Ohm or so depending on the drive capability of the target and adapter) connect TDO directly to SWDIO.” Without wiring this resistor in this way, a connection will not be established.
What kind of internal flash does Atmel PIC16F use?
Old MCUs from vendors like ATMEL and MICROCHIP, like the PIC16F and Atmega family, tend to have a special programming interface to program internal flash. For example, Atmega used SPI pins (MISO, MOSI, SCK) and PIC used two pins (PGC, PGD)— one as a clock and another as a bi-directional data line.