Contents
When should coaxial cable be used?
Applications. Coaxial cable is used as a transmission line for radio frequency signals. Its applications include feedlines connecting radio transmitters and receivers to their antennas, computer network (e.g., Ethernet) connections, digital audio (S/PDIF), and distribution of cable television signals.
Why do we use an oscilloscope probe in the X10 configuration rather than the X1 configuration?
The x10 scope probe achieve a better high frequency response than a normal X1 probe for a variety of reasons. It does this by decreasing the resistive and capacitive loading on the The X10 probe can often be adjusted, or compensated, to improve the frequency response.
Why do we need an oscilloscope probe?
An oscilloscope probe provides a quality connection between the signal source—or device under test (DUT)—and an oscilloscope. There are a number of important considerations when choosing and using an oscilloscope probe, including the physical attachment, impact on circuit operation, and signal transmission.
Is coaxial the same as RF?
While coaxial refers to how the cable is built, with conductors sharing a common axial (middle point), RF makes reference to what is being transmitted through the cable (specifically Radio Frequency signals and general electrical signals transmitted by a conductor for eventual transmission over the air or reception …
What is the difference between oscilloscope probe and function generator cable?
Function generators are signal sources which provide a specifiable voltage applied over a specifiable time, such as a “sine wave” or “triangle wave” signal. Oscilloscopes are a type of signal analyzer—they show the experimenter a picture of the signal, usually in the form of a voltage versus time graph.
Does it matter what coaxial port I use for internet?
A coax cable can transmit enough data for both TV and internet service. And to get faster speeds, you need to get more bandwidth. Most TV and internet providers have better deals when you bundle both services together since both services can work through the same network.
What kind of coaxial cable is used for an oscilloscope?
This probe is essentially a high-quality 50-Ohm coaxial cable with a tip that has a 450 Ohm series resistor, which forms 10:1 divider into 50-Ohm cable: The resulting input impedance is just 500 Ohms, but for a 50-Ohms signal source it changes the signal just by 10%, which is frequently good enough.
What kind of probe looks like a coaxial cable?
In some cases even 500 Ohms probe tip can be considered “high impedance probe”, and there are “passive” probes that are 10:1, and look like a simple coaxial cable, see for example the P6150 Tektronix “probe”.
What is the impedance of an oscilloscope probe?
The resulting input impedance is just 500 Ohms, but for a 50-Ohms signal source it changes the signal just by 10%, which is frequently good enough. The major advantage of this kind of probes is that they are limited only by quality of cable (and bare input bandwidth of the scope), and P6150 works up to 9 GHz.
How is the oscilloscope input resistance and attenuation ratio determined?
The oscilloscope input resistance, R2, provides a matched termination for the low loss coaxial cable. Ideally, the terminated cable presents a pure, 50W, resistive load to the input resistor, R1, at all frequencies. The probe input resistance and attenuation ratio is determined by the series resistor, R1.