Contents
Is there a problem calling component attribute In LTspice?
I have a problem in LTSpice with calling “component attribute” on both versions IV and XVII. Normally you should be able to call the component attribute window by pressing Ctrl+RightClick on the component (for example a Diode). Then you can enter the values that are not within LTSpice library.
What is the best way to rotate a component In LTspice?
Rotate component in LTspice? What is the best way to rotate a component in LTSpice? The only way I know how to do it is to select it with the drag tool then use the rotate button on the command bar. But then the damn component gets dragged all the way up to the top of the screen. Is there a better way?
How do you change the name of LTspice?
LTSpice labels components as R1, R2, R3, C1, C2, C3 and so on. You can change them for easeof recognition to things like Rc, Rb1, Rb2, Load and so on. Right click the label and type inyour new name.
How do you clear the resistor on LTspice?
Start LTSpice and press the new document icon on the left, a sheet of paper with the LTlogo on it. Press the ‘R’ key or click the resistor icon. Use your mouse to move the resistor to thetop center of the page, about one dot below the top, and click. Press ESC to clear theresistor mode.
Where can I find the general attribute editor?
Sometimes it is desired to get direct access to every available component attribute to edit their contents and visibility. An editor that allows you to do this can be reached by placing the mouse over the body of a symbol, holding down the control key, and clicking the right mouse button.
When to use your or M In LTspice?
If the symbol is intended to represent a SPICE primitive, the symbol should have the appropriate prefix, R for resistor, C or capacitor, M for MOSFET, etc. See the LTspice reference for a complete set of SPICE primitives available. The prefix should be ‘X’ if you want to use the symbol to represent a subcircuit defined in a library.
When to use the prefix x In LTspice?
See the LTspice reference for a complete set of SPICE primitives available. The prefix should be ‘X’ if you want to use the symbol to represent a subcircuit defined in a library.