Contents
How do I set up W1209?
In the main menu interface P3, press the SET key to enter setup, press “+” “-” set the minimum temperature can be set (minimum -50), press SET to return after the completion of a long press SET or 10 seconds without keystroke controller automatically confirm completion.
How do you use a W1209 temp controller?
Instructions for use: press the “SET” button, press ” + or – ” to set the desired temperature (long press ” + or – ” to quickly increase or decrease), press “SET” to confirm the setting and return, controller automatically performs the relay ON/OFF.
How do I reset my temp controller W1209?
Reset the Controller: Hold both + and – a while to reset to factory settings. After 5 seconds the Controller will return to thermostat function.
What is W1209 temperature controller?
Description. The W1209 is an incredibly low cost yet highly functional thermostat controller. With this module you can intelligently control power to most types of electrical device based on the temperature sensed by the included high accuracy NTC temperature sensor.
How do you set a digital temperature?
To record a temperature orally using a digital thermometer:
- Reset the thermometer by pressing reset button.
- Place the thermometer under the tongue.
- Close mouth around thermometer.
- Leave in place until you hear the beep (usually one minute or less)
- Read the level shown on the digital display.
How do I adjust the temperature on my temp controller?
How to View & Change Your Digital Temperature Controller…
- Press and immediately release the SET key. The display will show the setpoint value.
- Press and immediately release the SET key or wait for 15 seconds to display the enclosure temperature again.
How do you set a digital temperature controller?
How do I use a temp controller?
Temperature controllers are also used in ovens. When a temperature is set for an oven, a controller monitors the actual temperature inside of the oven. If it falls below the set temperature, it sends a signal to activate the heater to raise the temperature back to the setpoint.
What is temperature control loop?
A temperature control loop is designed to measure and control the temperature of a process. A typical process whose temperature is required to be controlled is an Oven which has a heater. Another very common process in the home is water bath temperature in a water heater whose temperature is controlled by a thermostat.