Contents
What is the operating voltage of the ir2110 MOSFET driver?
The IR2110 is a high voltage, high speed power MOSFET and IGBT driver with independent high and low side referenced output channels. Operating supply voltage range for IR2110 is 10 to 20 volt and output current is 2.5A. IR2110 comes in 14 pin through-hole PDIP package and the 16-pin surface mount SOIC package. IR2110 Pin Configuration
What are the applications of the ir2110 driver?
IR2110 Applications 1 DC motor driver 2 AC Motor Speed control 3 Half, full and three-phase bridge 4 Pure sine wave inverter 5 Soft starter for three-phase induction motor More
Is the i2110 pinout the same as ir2212?
Because IR2212 and I2110 both are almost the same and their pinout is the same. I recommend you to use IR2112 also in your project. It can provide Gate voltage between 10-20 volts. For the high side of the H-Bridge circuit, the bootstrap operation operating range is +500V or +600V.
Where does the VCC go in an ir2110 gate driver?
The VCC is directly connected to the drain of internal MOSFET of low side driver (as shown in internal circuit diagram of IR2110) and it can be in between 10V to 20V. For testing the IR 2110 IC, 5V is taken as VDD and 12V is taken as VCC.
Why is the ir2110 not connected to ground?
However, you’d be wrong. While they are not internally connected, IR2110 is a non-isolated driver, meaning that VSS and COM should both be connected to ground. HIN and LIN are the logic inputs. A high signal to HIN means that you want to drive the high-side MOSFET, meaning a high output is provided on HO.
How does the high low side driver ir2110 work?
While they are not internally connected, IR2110 is a non-isolated driver, meaning that VSS and COM should both be connected to ground. HIN and LIN are the logic inputs. A high signal to HIN means that you want to drive the high-side MOSFET, meaning a high output is provided on HO.
Do you need vss-25v for ir2110 driver?
I am using the IR2110 IR2110 datasheet to drive a full bridge. The datasheet says that Vss ( logic ground ) may be up to 25V less than the voltage that powers the driving side Vcc. In my case I need to have Vss -25V.