Contents
How do I connect molex to computer fans?
To do this, plug the fan into your computer’s power supply. The fan will contain either a male or female Molex connector, and sometimes both. The male connector is larger and slides over the female connector. If your fan has both types of connectors, you need only connect one of the two to the power supply.
Can I cut Molex connector off fan?
No. The fan is wired so that it can take power either from the 3/4-pin motherboard header, or from the 4 pin molex. Thus the power from the 3/4-pin and molex are running parallel to one another. If you snip that wire and it shorts, you are essentially shorting the same power terminals leading to your motherboard.
Where do you plug in Molex connectors?
the molex connectors are to connect the fans directly to the PSU. The female part of the Fan-Molex-Connector to the male connector of the PSU. The male part of the fan is just so you don’t lose a connector by using the fan and can connect to any other molex female connector in your setup to supply power.
Can you control fans through molex?
Best thing to control them: Sunbeam Rheobus. It’s has been one of the best (some say it’s the ONLY) fan controllers on the market and it’s a true darling of these forums. It comes with at least two adapters that you’ll plug into the Molex connectors of your fans and then plug into the Rheobus.
What is a Molex power connector?
Power Supply Connectors These “Molex” connectors bring DC power to the drives inside a PC case. The large one on the right is used for disk, CD-ROM and DVD drives, while the small connector is used for floppy drives and other devices.
How do you remove a Molex connector?
To disconnect a Molex connector (male and female connection), simple press down on outside clip and pull the connectors apart. The power connectors have hooks that allow the connectors to latch into the connector housing. Once the crimped wire has been inserted into the housing, it will be difficult to remove.
What does a Molex connector look like?
Molex connector is the vernacular term for a two-piece pin and socket interconnection. In such a connector, cylindrical spring-metal pins fit into cylindrical spring-metal sockets. The pins and sockets are held in a rectangular matrix in a nylon shell.