Contents
How much power does a Molex connector provide?
54 watts
The ATX standard for SATA or Molex connections is rated for 54 watts. Each SATA/Molex connector provides three 12v pins at 1.5 amps each, for a total of 4.5 amps. 12 volts, times 4.5 amps, equals 54 watts able to be provided by a SATA/Molex connector.
Are Molex connectors good?
Molex is a brand, not a style. They make hundreds of thousands of different connectors and are one of the biggest interconnect manufacturers in the world. Their quality ranges from ok to excellent. They are typically fine for many mate/de-mate cycles, often in the hundreds of cycles for gold contacts.
What should be connected to the Molex connectors?
What devices use a Molex connector?
- Hard drive.
- Disc drive (e.g., CD-ROM, DVD, Blu-ray.)
- Video card.
How much power does a riser draw?
As mentioned on our detailed discussion on riser cards the PCIe slot uses both 12V and 3.3V power. The PCIe spec specifies a max of 3 Amps of 3.3V power and 5.5 Amps of 12V power. That translates to 66 Watts of 12V power and 9.9 Watts of 3.3V power.
Why are Molex connectors hated?
Cons: It’s bulky and when manufactures make them cheaply, they don’t align properly and you have to wiggle both sides around for a few minutes to connect them. It only provides 5v and 12v power while SATA provides 3.3v, 5v, and 12v. Pros: The connector is much easier to de-pin than SATA.
How do I change a Molex connector?
To disconnect a Molex connector (male and female connection), simple press down on outside clip and pull the connectors apart. The power connectors have hooks that allow the connectors to latch into the connector housing. Once the crimped wire has been inserted into the housing, it will be difficult to remove.
What are Molex connectors used for?
These “Molex” connectors bring DC power to the drives inside a PC case. The large one on the right is used for disk, CD-ROM and DVD drives, while the small connector is used for floppy drives and other devices.
Can a Molex terminal pin be crimped automatically?
Crimped connectors also work well in a production environment. Molex makes automatic crimping tools and dies, which can feed terminal pins and wires, doing many many crimps automatically per minute. After talking to the Molex tech advisors, they admitted this: “Hand crimpers are a necessary evil.
What’s the current rating of a Molex IDC connector?
IDT/IDC versus Crimped Connector Current (Power) Ratings. Molex and Panduit (Panduit was used by Williams Electronics on their WPC pinballs) IDC connectors are rated at 7 amps and 8 amps respectively with 18 gauge wire. But this rating is for 20 degrees C (68 degrees F).
Why are connectors usually made of molded plastic?
Connectors allow design flexibility: Connectors give engineers the flexibility to design and integrate new products and components into existing systems. Housing. Usually made of molded plastic, a housing is a connector’s casing.
How are connectors used in the manufacturing process?
Connectors improve manufacturing: Connectors make it easier to assemble electronic products. They also facilitate mass production processes. Connectors ease repairs: If an electronic component fails, connectors allow a technician to quickly replace it with a new one. Connectors permit upgrades: