Contents
Can I use Windows commands on Linux?
Run Linux tools from a Windows command line Run Linux binaries from the Windows Command Prompt (CMD) or PowerShell using wsl (or wsl.exe ). Binaries invoked in this way: Use the same working directory as the current CMD or PowerShell prompt.
What is the difference between Windows and Linux command line?
The difference is the operating system. The command prompt (cmd) and a terminal emulator (linux bash shell or similar) are text interfaces to the operating system. They allow you to manipulate the file system and run programs without the graphical interface. You should read about Linux shells.
Does KiCad use SPICE?
KiCad uses ngspice internally to perform SPICE based circuit simulation. The typical power supplies used when creating schematics will not be understood by the SPICE engine. Place a new VSOURCE voltage source component (located within the pspice library) into the schematic.
Can I install Linux on Windows 10?
Yes, you can run Linux alongside Windows 10 without the need for a second device or virtual machine using the Windows Subsystem for Linux, and here’s how to set it up. In this Windows 10 guide, we’ll walk you through the steps to install the Windows Subsystem for Linux using the Settings app as well as PowerShell.
How to call Ngspice from the command line?
If you are with Linux, you might put vdiv.cir into a folder of your choice. Then cd into that folder and call ngspice from your command line window. You will not need the source command, when you directly call Then the circuit is loaded immediately, and the next command you enter is op (see above).
How to run Spice from the command line?
I have a spice file, SPICE.cir, that I am able to run on a Linux machine from the command line using the command where ngspice executes SPICE.cir and returns the results to the file out.txt However, if I run this same command on my windows machine an interactive ngspice terminal opens and the file out.txt is created, however, it is empty.
How to start a simulation in ngspice.exe?
Now start ngspice by double click onto ngspice.exe in C:\\Spice64\\bin. Load the netlist into ngspice by entering the command source vdiv.cir . ngspice is now ready for simulation, the netlist is loaded. What kind of simulation do we now want to have?
How to start Ngspice with vdiv.cir file?
Put these lines into a text file named vdiv.cir and save it to the folder C:\\Spice64\\bin (If you are with MS Windows). Now start ngspice by double click onto ngspice.exe in C:\\Spice64\\bin. Load the netlist into ngspice by entering the command source vdiv.cir . ngspice is now ready for simulation, the netlist is loaded.