Why is local oscillator frequency kept higher in superheterodyne receiver?

Why is local oscillator frequency kept higher in superheterodyne receiver?

The frequency of the local oscillator fLO is set so the desired reception radio frequency fRF mixes to fIF. Most other signals produced by the mixer (such as due to stations at nearby frequencies) can be filtered out in the IF tuned amplifier; that gives the superheterodyne receiver its superior performance.

Why local oscillator is used?

In electronics, a local oscillator (LO) is an electronic oscillator used with a mixer to change the frequency of a signal. This frequency conversion process, also called heterodyning, produces the sum and difference frequencies from the frequency of the local oscillator and frequency of the input signal.

What is the difference between the local oscillator frequency and the received signal frequency?

The local oscillator will be operating at a frequency of 1090 MHz. The received and local oscillator signals are mixed, or heterodyned, in the converter stage and one of the frequencies resulting from this mixing action is the difference between the two signals, or 60 MHz, the IF frequency.

Why if frequency is 455 KHz?

Uses. Perhaps the most commonly used intermediate frequencies for broadcast receivers are around 455 kHz for AM receivers and 10.7 MHz for FM receivers. A first intermediate frequency may even be higher than the input signal, so that all undesired responses can be easily filtered out by a fixed-tuned RF stage.

Why is the superheterodyne AM receiver preferred over other AM receivers?

Superheterodyne receivers have better performance because the components can be optimized to work a single intermediate frequency, and can take advantage of arithmetic selectivity.

Why if frequency is 455 kHz?

Is the local oscillator higher than the carrier frequency?

In most cases the local oscillator frequency is made higher than that of the required carrier so that Fig. 9.26. A superhet receiver. where fLO is the local oscillator frequency, fS is the r.f. signal carrier frequency and fIF is the intermediate frequency.

Which is an example of a local oscillator?

The block diagram of a superhet receiver is shown in Figure 9.26. This example has only one tuned r.f. stage, as is common practice in many cases. Its tuning is ganged to that of an LC sine wave oscillator called the local oscillator, but with the two tuned circuits having a frequency difference called the intermediate frequency (IF).

How does the oscillator work on a radio?

The incoming broad range of many radio stations were “mixed” with an oscillator that can be simply tuned with a dial – this produced sum and difference frequencies and usually the difference frequency became the new “wanted” frequency.

Why does the oscillator reject 108mhz as intermediate frequency?

There is a sensible reason – if the oscillator were exactly tuned to pick up 88MHz (i.e. osc = 98.7MHz) the difference frequency it would produce from the top of the band at 108MHz would be 9.3MHz and this would be just out of band of the tuning centred at 10.7 MHz and therefore “rejected”.