Contents
What is continuous conversion mode?
In continuous conversion mode, the ADC analog input is continually converted and written to the ADC result data registers. In this mode, data from the previous conversion is overwritten regardless of whether that data had been read or not. The ADC offers two different ways to monitor the conversion complete status.
What is dual ADC mode?
Description. The dual regular simultaneous ADC mode is used to perform two conversions simultaneously owing to the synchronization of ADC1 and ADC2. Each ADC converts a channel sequence (with scan enabled and the sequencer of each ADC configured) or converts a single channel (scan disabled).
What does conversion mode mean?
Mode conversion occurs when a wave encounters an interface between materials of different impedances and the incident angle is not normal to the interface. The larger the difference in wave speeds between the two materials, the more the wave is refracted.
How do I use ADC stm32?
To do that you will need the following:
- Enable the ADC clock.
- Enable the GPIO clock for the pin you want to use.
- Configure the GPIO pin as an analog input.
- Configure the ADC speed (prescaler/sample time)
- Enable continuous measurement mode.
What is EP recording mode?
EP/SLP is short for extended play. Extended play is similar to LP, but actually provides you even more recording time. EP was primarily used to document long, continuous events without the need to change video tapes every 2 hours.
How do I change the recording mode on a VCR?
On modern VCRs, the recording speed settings are changed via the remote control. A button marked “SP/LP/EP” will make the change while recording video. SP is the default recording speed on VCRs. Additionally, a VCR may have the recording speed setting button on the body of the VCR, marked in a similar fashion.
What are the two ADC conversion modes in STM32?
STM32 microcontrollers support two ADC conversion modes: regular and injected. The proper way is to see in many types of microcontrollers – all channels share the same data register. Various regular modes can be possible, like single, continuous, and group.
When is the end of sequence flag triggered in stm32f0?
Each time the channel conversion is done, the End of Conversion (EOC) interrupt flag will be triggered until the last channel, End of sequence (EOS) will be on. Illustration of 2 channels, continuous mode disabled, and discontinuous mode disabled analog to digital conversion process.
How does discontinuous mode work in STM32?
In discontinuous mode, parts of the group can be triggered to convert. For instance, if we select a group to be 16 channels, we can program to convert the first three channels on the trigger, then wait for another trigger, convert the next three channels, etc. Another is injected conversion mode.
Is the stm32f0 discovery board an ADC module?
Specifically, I will cover almost every part of Analog-to-Digital Converter (ADC) module of STM32F051 on STM32F0 Discovery board using HAL library with support from STM32CubeMX. This is applicable for other low level STM32 series as their ADC module are quite similar.