Contents
How to calculate Vout in voltage divider calculator?
Vout= (Vin x R2) / (R1 + R2) Where, Vout= Output Voltage Vin=Input Voltage and R1=Upper Resistor R2=Lower resistor. We can use the above voltage divider calculator to calculate any one of the value mentioned in the voltage divider formulae, but now let us learn how this formulae was derived.
How is the output voltage determined in a voltage divider?
A voltage divider circuit is very simple circuit consisting of only two resistors (R1 and R2) as shown above. The required output voltage (Vout) can be obtained across the resistor R2. Using these two resistors we can convert an input voltage to any required output voltage, this output voltage is decided by the value of the resistance R1 and R2.
When do you need a potential divider circuit?
A potential divider circuit is a very common circuit used in electronics where an input voltage has to be converted to another voltage less than it. This circuit is very useful for all analog circuits where variable voltages are required, hence it is important to understand how this circuit works and how to calculate the values of Resistors.
Can a voltage divider be applied to more than two resistors?
The above circuit shows the voltage divider between the two resistors which is directly proportional to their resistance. This voltage divider rule can be extended to circuits that are designed with more than two resistors.
How to calculate Vout for a resistor R2?
The required output voltage (Vout) can be obtained across the resistor R2. Using these two resistors we can convert an input voltage to any required output voltage, this output voltage is decided by the value of the resistance R1 and R2. The formulae to calculate Vout is shown below. Vout= (Vin x R2) / (R1 + R2)
How is the output voltage of a voltage divider determined?
Output voltage of voltage divider is dependent on the resistance of the incoming load. A voltage divider circuit will normally look like this in a circuit with a series of 2 resistors. Equation to find the output voltage of a Divider Circuit: R2 / R1 + R2 = Ratio determines scale factor of scaled down voltage.