Contents
How do you use a transistor properly?
One of the most common uses for transistors in an electronic circuit is as simple switches. In short, a transistor conducts current across the collector-emitter path only when a voltage is applied to the base. When no base voltage is present, the switch is off. When base voltage is present, the switch is on.
How do you know which way a transistor goes?
Transistors typically have one round side and one flat side. If the flat side is facing you, the Emitter leg is on the left, the Base leg is in the middle, and the Collector leg is on the right (note: some specialty transistors have different pin configurations than the TO-92 package described above).
How are transistors used as switches?
One of the most fundamental applications of a transistor is using it to control the flow of power to another part of the circuit — using it as an electric switch. Driving it in either cutoff or saturation mode, the transistor can create the binary on/off effect of a switch.
What is the rule of transistor?
Rule 1: The collector voltage must always be greater than the emitter by approximately 0.2V. Rule 2: The base-emitter and base-collector circuits in a transistor act like diodes. Rule 3: Transistors all have maximum current and voltage ratings.
Why transistors are called BJT?
Bipolar transistors are so named because the controlled current must go through two types of semiconductor material: P and N. The current consists of both electron and hole flow, in different parts of the transistor. Bipolar transistors consist of either a P-N-P or an N-P-N semiconductor “sandwich” structure.
How do you use a transistor as a switch?
Some of the basic Applications of Transistor as a Switch. In a transistor, unless a current flows in the base circuit, there is no current can flow in the collector circuit. This property will allow a transistor to be used as a switch. The transistor can be switched ON or OFF by changing the base.
How does a transistor work as an amplifier?
A transistor acts as an amplifier by raising the strength of a weak signal. The DC bias voltage applied to the emitter base junction, makes it remain in forward biased condition.
How does a transistor work as a switch?
Transistors can also work as switches. A tiny electric current flowing through one part of a transistor can make a much bigger current flow through another part of it. In other words, the small current switches on the larger one. This is essentially how all computer chips work.
What is a transistor and how does it operate?
A transistor is a miniature electronic component that can do two different jobs. It can work either as an amplifier or a switch: When it works as an amplifier, it takes in a tiny electric current at one end (an input current) and produces a much bigger electric current (an output current) at the other.