Contents
What does a DC signal look like on an oscilloscope?
DC (direct current) waveform: A flat, straight line. AC (alternating current) waveform: This waveform undulates over time. The most common AC waveform is a sine wave, but you may also encounter triangle waves, sawtooth waves, and other AC waveform shapes.
What is a DC sweep?
DC Sweep Analysis is used to calculate a circuits’ bias point over a range of values. This procedure allows you to simulate a circuit many times, sweeping the DC values within a predetermined range. You can control the source values by choosing the start and stop values and the increment for the DC range.
Can we use the oscilloscope to measure DC voltages?
You can measure DC voltage with an oscilloscope that has a direct-coupled deflection amplifier or terminals for connecting directly to the cathode-ray tube’s deflection plates, but measuring DC voltage using an oscilloscope is only convenient in some situations — e.g., when you’re using the oscilloscope to take other …
How does a DC coupling oscilloscope work?
Similar to a very fast voltmeter, the voltage on the input of the oscilloscope is traced on the display with DC coupling, enabling you to observe large transitions and, when the voltage remains low or high, the trace correspondingly remains low or high.
How does the ground setting on an oscilloscope work?
The ground setting disconnects the input signal from the vertical system, which lets you see where zero volts is located on the screen. With grounded input coupling and auto trigger mode, you see a horizontal line on the screen that represents zero volts.
What does the Div setting on an oscilloscope mean?
The volts-per-division setting (usually written as volts/div) is a scaling factor that varies the size of the waveform on the screen. If the volts/div setting is 5 volts, then each of the eight vertical divisions represents 5 volts and the entire screen can display 40 volts from bottom to top, assuming a graticule with eight major divisions.
How do you adjust the amplitude of an oscilloscope?
Use the volts/div control to adjust the amplitude of the signal to the desired measurement range. Horizontal: This is the time base. Use the sec/div control to set the amount of time per division represented horizontally across the screen. Trigger: This is the triggering of the oscilloscope.