Contents
What is the highest output voltage for a real op amp?
A typical op-amp has an output voltage limit somewhere in the ±1 V to ±3 V range. Often the output is more limited towards one power rail than the other — it might be +2.7 V and -2.9 V, for example.
What is the maximum power supply used for op amp IC?
Its output can switch up to 50 volts and 50mA current. It works on wide range of supply voltages from 5 to 30 volts and requires only single supply. It can directly drive relays, solenoids etc if the current requirement is less than 50mA. The pin connection of LM311 is different from other OpAmps.
Can a opamp accept a direct feed signal?
Direct feed isn’t going to work well for you. You’ll find that the common-mode input range of an opamp is quite often less than the supply voltage rails (less than VCC, greater than VEE) . Some parts (those with rail-to-rail inputs) can accept signals at the same potential as the supply lines.
Which is more common mode, Vee or opamp?
You’ll find that the common-mode input range of an opamp is quite often less than the supply voltage rails (less than VCC, greater than VEE) . Some parts (those with rail-to-rail inputs) can accept signals at the same potential as the supply lines.
What’s the maximum supply voltage that can be applied?
The absolute maximum rated supply voltage is the maximum voltage that can be supplied between the positive supply (V CC) and negative supply (V EE) pins without causing characteristics degradation or damage to the internal circuit. Here is an example of a supply voltage that can be applied to opamps/comparators with a maximum rated voltage of 36V:
Can a voltage be higher than the postiive supply?
Usually there are p-n junctions between the opamp inputs and the rails (sometimes deliberate, often parasitic) which can forward-bias and fry if a stiff signal higher than the postiive supply or lower the than negative supply is applied.