Contents
What is the load current of the lm311 comparator?
LM311 is single voltage comparaotor, LM393 is dual voltage copatpr. LM311 has a load current of up to 50MA and a voltage of 40V. It can drive relays with a minimum power supply voltage of 5V.
Is the LM111 voltage comparator compatible with RTL?
The LM111, LM211 and LM311 are voltage comparators that have input currents nearly a thousand times lower than de- vices like the LM106 or LM710. ± 15V op amp supplies down to the single 5V supply used for IC logic. Their output is compatible with RTL, DTL and TTL as well as MOS circuits.
Where are the voltage inputs on the lm311?
An LM311 is a 8-pin chip. The pinout is shown below: The LM311 has 2 power inputs. These are labeled VCC and VEE. V CC, pin 8, is where the positive terminal of the voltage supply gets inserted into.
Can a differential comparison amplifier be used as a voltage comparator?
The lm311 differential comparison operational amplifier is a very old Ti comparison IC which has been used in voltage comparison with electronic design for a long time. Any operational amplifier can be used as a voltage comparator, but lm311 proves its advantage by placing an output transistor in its package.
Can a lm311 be used in a MOS circuit?
LM311 requires very low input current at bias and offset. Can be operated with wide supply voltages. It can drive load up to 50V with 50 miliampere. The input and output of the IC can be isolated from circuit’s ground. The IC can easily be used with TTL and MOS circuits.
What is the operating temperature of the lm311?
The input current of LM311 is around one thousand times smaller than its standard counterparts. The operating temperature range is from 0 to 70°C. LM311 is available as 8-pin SO, 8-pin SOIC, 8-pin PDIP, and 8-pin TSSOP packages. The 8-pin packages have pin-outs as shown: The operational features of LM311 are shown as:
What’s the difference between lm311 and LM393?
If you want the foward output result, pin 7 is connected to the positive power supply and pin 1 is the output. If the result is to be output in reverse, pin 1 is grounded and pin 7 is the open collector output. lm311 and lm393 are both voltage comparators, so what is the difference between them?