Contents
What do you need to know about Eagle autorouter?
You’re in complete control of the autorouter setup with settings for effort, CPU threads, and routing directions. Preferred direction: if you need a specific direction of the route, like vertical or horizontal, select it for each layer or you can set it to Auto.
What should gap be between pads and traces in Eagle?
As a bare minimum, we recommend always leaving a gap of 0.007” to 0.010” between all adjacent pads and traces on your board. In Autodesk EAGLE you have complete control over your snap grid settings, which comes in handy during both your component placement and routing process.
Is the autorouter a replacement for manually routing?
The autorouter is a useful tool that creates many routing variations for the current component placement. However, it is not a completely replacement of manually routing method. It can help you in specific situations to augment your abilities, not replace them. When to use the autorouter? There are three main uses of the autorouter:
How to remove trace segments in routing mode?
Removing trace segments while you route comes in very handy when you need to make adjustments on the fly without getting out of routing mode. Let’s try it: Begin your routing process by selecting the Route tool then left-clicking a net and dragging out a trace.
How to set autorouter to only use one layer and?
For whatever layer you don’t want to route on set the direction to N/A. This will stop the autorouter from using that layer. The board size is defined by the outline on the dimension layer, so you can use the wire tool to draw the outline to the size you see fit.
When to call Eagle autorouter, when to use electronics lab?
When you are stuck on a section and don’t know how to route your parts, then you can call the autorouter to see how it takes care of the job, then try routing that same spot yourself with your new perspective. You might just find a strategy for your traces that you didn’t see before your autorouter gave it a try.
What are the three main uses of autorouter?
There are three main uses of the autorouter: While there is no rule for placing the components of the circuits, you need to evaluate your placement to ensure that you can route all parts. Autorouter completion result could be used as an indicator of your parts placement, if it was 85% or greater this means you did a good job.