Contents
What are the different types of board to board connectors?
Board stacking interconnects for low profile, elevated, pass-through, and rugged applications on .100″ (2.54 mm) and 2.00 mm pitch. .100″ (2.54 mm) pitch sockets, headers, terminals and board stackers in low profile, elevated, and high-density designs to connect multiple boards together.
Why do you need pegs for board to board connectors?
Locating pegs (also referred to as locating posts, alignment pins or board locks) are used to assist alignment of connectors to the PCB. Locating pegs are particularly useful when using surface mount components. Pitch refers to the spacing between individual pins.
What’s the maximum power of a board to board connector?
Maximum power per linear inch, up to 100.0A per bay blade, ideal for next-generation computing applications High-current, custom configurable, high-power, board-to-board connector system delivering up to 350.0A per inch
How are MICTOR board to board connectors made?
The MICTOR connector family is based on the microstrip concept of two rows of signal contacts divided by a center power ground plane. The connector system uses the solid ground bar between the rows of signals to provide low crosstalk and excellent high-speed signal characteristics.
Connector styles. Board to board connectors are manufactured in the following types: Pin header (also known as male header) Elevated pin header (also known as stacked, stacker, mezzanine and PC104 headers) Shrouded header (also known as box header) Socket (also known as female header or receptacle)
How to calculate board to board connector stacking?
A good starting point when calculating PCB connector stacking is to calcualte the board to board connector height. This is measured from the printed circuit board face to its highest insulator point above the PCB is known as its profile. See some examples below:
What are recommended practices in a layout module?
Recommended Practices (RPs) are those practices that the Standards Department has established through actual tests and feel are beneficial to operation. These are not required to be voted by the membership except when in a package such as the Module Standards and RPs. These are presented to the Board of Directors (BOD) for their study and approval.