How do I move the cursor in LTspice?
You can also attach the 1st or 2nd cursor or both cursors to any trace by right clicking on that trace’s label and using the Attached Cursor drop down box. The attached cursors can be dragged about with the mouse or moved with the cursor keys.
What is cursor in LTspice?
When viewing a graph, you can attach a cursor to a trace by clicking on the trace’s name: Attaching a cursor to a trace allows you to see the exact value of the graph at the cursor point. This is handy for finding -3 dB location, Vgs threshold, etc.
How can I see values in LTSpice?
hi, After you have plotted the graphs, place your cursor on the crossing point on the graph. Look at the bottom left of the LTS window at the Status bar, it will display the values under the cursor pointer as you move the cursor.
How do I get grid in LTspice?
To activate the grid mode, click on View and select command Show Grid. There are many buttons on the main menu for selection of basic circuit elements such as resistors, capacitors, inductors, diodes, wires, as well as a ground node (GND). The Ltspice IV’s Main toolbar is shown on Fig. 2.
How is the Bode plot displayed in LTspice?
The standard Bode plot displayed in LTspice is given as a function of frequency f. A modified method, which is not discussed here, must be used if the plot should be displayed with the angular frequency ω.
How to select one cursor In LTspice Part 2?
Move the mouse to the ‘Vout’ logo at the top of the plot pane and right click. This brings up a menu to enable us to select between 1 cursor or 2. Selecting a single cursor results in FIG 6.
How to position the cursor in a Bode diagram?
You can view the available data points via right click and Mark Data Points You can navigate your cursor to the next data point using the left and right arrow key on your keyboard. If you just want to determine a maximum value, you can use a .MEASURE directive. (Use the .op button to place a custom directive on the schematic)
Which is the best tutorial for LTspice circuit design?
This LTspice tutorial will explain how to modify the circuit and apply some different signals to it. To save you constructing a new schematic, download this file: 2nd order Butterworth low pass filter. The circuit is shown in FIG 1