Contents
Can an oscilloscope measure RF?
If an accurate 50Ω dummy load is available in the shack, we can measure RF power by measuring the RF voltage developed across the load. If a calibrated oscilloscope is available, we can connect our 10X scope probe across the dummy load, apply a CW signal from the transmitter, and measure the peak-to-peak voltage Vp-p.
What does an RF extender do?
A 2x extender is a small lens that mounts between a compatible lens and a camera, increasing the focal length or focal length range of the lens by a factor of 2x. This difference is a drastic, creating a dramatically narrower angle of view.
Can a RF 433.92 MHz transceiver communicate to an Arduino?
The idea is to avoid using the remote control which works on 433.42 Mhz and use a simple RF transmitter and an Arduino. The thing is that I can not find any transceiver at such frequency. I only can get RF 433.92 Mhz transceiver like RFM69 @ 433 MHz among others that only mention 433 Mhz without precision.
Can a Somfy transmitter communicate with a 433.42 MHz receiver?
Somfy use 443,42Mhz for carrier and RTS rolling code. Independantly of rolling code, 443 generic transmitter and receiver (as low cost chinese modules) use 443,92Mhz Frequency.
How does a 433mhz RF remote control circuit work?
5-Channel 433MHz RF remote control receiver circuit: In the 433MHz RF receiver circuit there are 5 LEDs and an RF receiver. The RF receiver receives radio signals transmitted from the RF transmitter. Each LED is remotely controlled from one button in the transmitter circuit.
How is a RF transmitter connected to a receiver?
The RF transmitter is the element that sends the RF signals to the RF receiver circuit. PIC12F1822 internal pull-ups are enabled by the software and the internal oscillator is used as usual. In the circuit there are 5 push buttons connected to RA0, RA1, RA2, RA3 and RA4 which means that pins must be configured as inputs and the RA5 pin as output.