Contents
How do I connect two DTE devices?
You can therefore connect a DTE device to a DCE using a straight pin-for-pin connection. However, to connect two like devices, you must instead use a null modem cable. Null modem cables cross the transmit and receive lines in the cable, and are discussed later in this chapter.
Why is RS-232 not working?
The most common cause of serial port communication problems is incorrect communication parameter settings. To operate correctly it is essential that both devices are set up with the same communication parameters, which includes baud rate, parity, number of data bits, and number of stop bits.
How many devices can be connected to RS-232?
This allows up to 32 devices on a single network without repeaters. The devices can also be connected up to 4000 feet away from the PC. The disadvantage is that each device must have its own unique address.
Can you have multiple devices on RS232?
Just like I2C which is addressed and half-duplex. Think about it…for RS-232 each device as a TX and RX line right? ANd each device can use both at the same time. You are going to have to connect the TX pin on every device to the RX pin on every other device.
How to connect two devices using RS-232?
Connecting two devices using RS-232 sounds simple, but nearly every day we help a customer get a converter, isolator or other RS-232 device working by helping correct the RS-232 cabling connections. This FAQ will help you troubleshoot and correct such problems. Usually inputs are connected to inputs and outputs to outputs.
Can a controller receive more than one RS232 signal?
Unfortunately, my controller has only one RS232 output. Can I tap another RS 232 from the existing signal cable (by stripping the cable, taking out parallel signals and all)? Or I need to use any custom hardware or cable? Ah well, that was my original question, and I did try using the circuit, the problem is I can receive data only on one terminal.
How to tell if a DCE port is RS-232?
Use RS-232 Line Tester – A quick and easy way to determine the DTE/DCE port type is to use a RS-232 line tester such as the 9PMTT. The tester can show the signal state of any active RS-232 data lines using LED’s lighting Red or Green. Active data lines are output from a device, they may be either High or Low.
Where is the RS-232 serial port on a computer?
In the old days of personal computers, one of the primary connections available was the RS-232 serial port. Apart from the parallel port, it was the primary means to connect an external device. The connector was reduced from a 25-pin connector to a 9-pin connector, but RS-232 ports remained present on every computer for many years.