What is DDR initialization?

What is DDR initialization?

Introduction. The double data rate (DDR) synchronous dynamic random access memory (SDRAM) device is a volatile and complex memory device. When power is removed from the device, all contents and operating configurations are assumed to be lost.

What is DQ calibration?

ZQ Calibration is related to the data pins [DQ]. It is responsible for sending data back during reads and receiving data during writes. Figure 4: DQ calibration block. Now, if you look within a DRAM, the circuit behind every DQ pin is made up of a set of parallel 240Ω resistor legs, as shown in Figure 4.

What is SDRAM used for?

SDRAM, or Synchronous Dynamic Random Access Memory is a form of DRAM semiconductor memory can run at faster speeds than conventional DRAM. SDRAM memory is widely used in computers and other computing related technology.

How does DDR SDRAM work?

It is a memory technology based on Synchronous dynamic random access memory (SDRAM). DDR SDRAM access is twice as fast as SDRAM, because DDR data transfers occurs on both edges of the clock signal as compared to SDRAM which transfers data only on the rising edge of a clock.

What is meant by ZQ calibration?

ZQ calibration is a process that tunes the DRAM and ESDCTL I/O pad output drivers (drive strength) and ODT values across changes in process, voltage, and temperature. There are two instances where ZQ calibration is performed: on the i. MX53 (DDR pads) and on the DDR device.

Do you need to initialize SDRAM in controller?

The SDRAM has some programmable settings (like the CAS latency), so there is a “MODE” register that needs to be initialized after power-up. A “LOAD MODE” command is used for that purpose. The SDRAM initialization could be added in the controller, or in a separate step before the controller is run. The heart of our controller is shown below.

How to initialize a SDRAM using a FPGA?

The initialization of an SDRAM, does no vary much from manufacturer one to another, but is very important to check always the datasheet to see the exact process: 1- Wait at least 100μs prior to issuing any command other than a COMMAND INHIBIT or NOP. 2- Starting at some point during this 100μs period, bring CKE HIGH.

What do you tell the DRAM during initialization?

Say you intend to do a WRITE operation, during initialization you tell the DRAM what the CAS Write Latency is by programming one of its Mode Registers ( CWL is the time delay between the column address and data at the inputs of a DRAM ), and you have to honor this timing parameter at all times.

When to use SDRAM in a burst mode?

Fast: SDRAM is used in burst mode if you provide continuous addresses. Simple: no scheduling, only one bank is active at a time. Powerful: SDRAM appears as a simple dual-port memory (i.e. with one writing agent and one reading agent). The most uncommon feature of the controller might be the last one.