What do I need to Desolder?
Desoldering tools and materials include the following:
- Solder wick.
- Heat guns, also called hot air guns.
- Desoldering pump.
- Removal alloys.
- Removal fluxes.
- Heated soldering tweezers.
- Various picks and tweezers for tasks such as pulling at, holding, removing, and scraping components.
Do I need flux to Desolder?
Flux’s job is to clean copper by removing impurities so that solder can properly wet (think “adhere”). When desoldering, you should apply flux to whatever the solder is supposed to wet to. If you are using a copper desoldering braid, then apply a bit of flux to it.
Why do you need to desolder circuit boards?
There are many reasons for why you’d want to desolder components from old PCBs (circuit boards). Need those old, high-quality components? Can’t afford new components? Don’t have time to wait for components to arrive in the mail? Want to annoy your (re)sister because she hates the smell of solder? HAVE YOU SEEN THIS?!?: THIS IS SHOCKING!
Do you need to know how to desolder components?
The skill of desoldering is a very useful skill to possess. If you can solder, you will at some point need to know how to desolder components that are wrong or need replacing and you can cause a lot of damage with a hot soldering iron if you don’t do it properly, usually as a cause of applying to much heat.
What do you need to know about desoldering?
Desoldering is the process of removing solder and components from a circuit board. It involves getting rid of one or more solder joints to free up the component before removing it. There are various methods through which this can be done. It is the opposite process of soldering, but can be done with mostly the same tools.
Which is the best desolder tip for PCBs?
Personally, I like the D-tips (as explained best in JColvin91’s Instructable: Uses of Different Desoldering Tips) since I do mostly “rough” soldering jobs. The B-tips are great for soldering components to PCBs, but transfer heat poorly and wear out faster from my experience. Step 2: Build (or Buy) a PROPER Circuit Board Holder!