Contents
How do I reset my XBee radio module?
Where is a switch “Reset” on XBee module?
- Insert module to adapter-board XBee-USB.
- Connect cable micro-USB to computer.
- Run X-CTU and press “Query/Request”.
- Have dialog-box “Press and release Reset Switch …”
How do I reset a Zigbee module?
Holding the Di line LOW for 4 seconds or holding the Di line LOW during a /RESET will cause the module not to reset the parameters or NWK layer but to force the module into AT command mode at 9600 8N1. Upon exiting command mode the module will return to whatever settings it had set before.
How do I restore XBee?
The XBee recovery tool is an embedded tool that you can use to force a firmware update on radio modules with damaged firmware. You can also use this tool to recover a radio module from programming mode. To open the XBee recovery tool, select XBee recovery from the Tools drop-down menu on the main XCTU toolbar.
Why Zigbee is better than Wi-Fi?
Zigbee network is more reliable as compared to Wi-Fi network. WiFi network is less reliable as compared to Zigbee network. It requires low bandwidth but greater than Bluetooth’s bandwidth most of time. It requires high bandwidth.
How to reset XBee X-CTU to working mode?
It is possible that X-CTU asks you to do a reset of the XBee in this step (or in the next steps). To do that, just press the button “RST” in your Gateway for 1 or 2 seconds. 4.4 – Then go to the Configuration Working mode and click to select the device. We must check each parameter first. 4.8 – The KY parameter (if needed).
Is the waspmote gateway compatible with XBee X-CTU?
When X-CTU has been properly installed, the Waspmote Gateway can be connected to the computer. It will be recognized as a ‘USB Serial Port’. We have to know the COM number given to this device in order to specify it in the X-CTU (in our test, COM1 was the value given by Windows, as seen later in Figure 2).
Is there a recovery procedure for X-CTU?
The “Next Gen” version of X-CTU does have a recovery feature, but for some of the more intricate steps it may not be sufficient to perform a full recovery of the module. If you have a programmable XBee, contact Digi Support for troubleshooting. The recovery procedure outlined in this article are for standard XBees and other Digi RF products.
How do I Reset my Digi XBee modem?
In the modem dropdown box, select the XBee type you are working with (If you are unsure, the part number is printed on the label located on the RF shield.) Click Show Defaults. Check “Always Update Firmware”. Click Write. You will most likely receive an “Action Required” prompt, follow the directions in the window press the reset button.