What does 3S mean on LiPo battery?

What does 3S mean on LiPo battery?

Each LiPo cell is rated at 3.7v so a 2S LiPo means it’s a 2 cell battery and 7.4v, a 3S is 11.1v, 4S is 14.8v and 6S is 22.2v.

What is 3C in lithium-ion battery?

The value 3C means that the battery can output 3 times the rated Ah rating as its maximum current. In this case it can supply upto 6A (3*2 = 6) as the maximum current. Normally 18650 cells have a 1C rating only. Charging Current: Another important specification of a battery to notice is its charging current.

What does 2S and 3S mean?

This is sometimes why you will hear people talk about a “2S” battery pack – it means that there are 2 cells in Series. So a two-cell (2S) pack is 7.4V, a three-cell (3S) pack is 11.1V, and so on.

What is the current rating of lithium ion battery?

This battery is rated at 3,200 mAh, meaning that in one hour, it can discharge 3,200 milliamps (3.2 amps) and then it’s done. That also means that if you want to do half that (1.6 amps) in an hour, then you would get two hours of power until the battery’s charge is depleted.

What is ESP 01 adapter?

This is a adapter module especially for ESP-01 Wi-Fi module. Onboard level conversion circuit and 3.3V voltage regulator circuit makes 5V microcontroller (such as Arduino board) easy to use ESP-01 Wi-Fi module.

Why do some LiPo batteries have 3 wires?

The third pin is usually found on Li-Poly, or Lithium Polymer batteries and is required in order to charge the battery safely. Because these batteries are usually multi-cell, the third pin is used for balancing the charge between each of the cells.

Do you need a lipo regulator for 3.3V?

To be honest, a LDO regulator is probably good enough. When a Li-Po cell gets down to 3.3V, it has delivered most of its power (see lipo discharge curve). Many devices (esp8266, nrf24l01, etc.) that state nominal 3.3V supply will operate well below 3.3V.

What is the capacity of a 3.3V LiPo battery?

Capacity as a factor of temperature and load: 400 mA = 0.4C. The left hand graph below from a Sanyo LiPo datasheet which was originally quoted. At 0.5C discharge the voltage drops below 3.5V at about 2400 mAh or 2400/2700 = 88% of nominal capacity of 2700 Ah.

How to get 3.3V from a lithium ion battery?

What would be the best way to convert the (changing) output voltage of a Lithium-ion battery into the required 3.3V to power my circuit with up to the peak current draw of 400 mA? By “best way”, I mean most efficient voltage conversion so as to make the best use of battery capacity.

What kind of voltage regulator does a 3.3V battery need?

You should look for a low drop out linear regulator which will regulate the battery voltage to 3.3V For example a TC1262 from Microchip has a drop out voltage of about 300mV at a normal current consumption of the ESP8266. If you prefer a ready-made module instead take a look at AMS1117 3.3V modules on Ebay.