Contents
Can you connect headphone output to microphone input?
The microphone input on the PC might not handle a headphone out from your phone or TV – if it does then it will sound rubbish. Get an RCA switch. There is 1 output and multiple inputs. Connect all the devices you want to use to the inputs – phone, tablet, pc and then connect the output to your wireless headphones.
What is line in line out in audio?
Consumer electronic devices concerned with audio (for example sound cards) often have a connector labeled line in and/or line out. Line out provides an audio signal output and line in receives a signal input.
What is a potential divider arrangement?
A potential divider is a simple circuit which takes advantage of the way voltages drop across resistors in series. The idea is that by using two resistors in series it is possible to divide a voltage and create a different voltage between them.
Can I use mic as line-in?
Line inputs are not designed for microphones. Although it is possible to use them and it won’t harm your mic, there is not enough gain to amplify the microphones level to a line input. If you have a mic with a jack plug on it you should change it for a XLR connector.
How do you use both headphones and mic?
Use both speakers and a headset with microphone on a sound card with both Speaker-Out and Line-Out Jacks. Some sound cards have both a speaker out and a line out jack. If you have both jacks, then your headphones can go in the speaker-out jack and your amplified speakers can go in the line-out jack.
Do headphones go in line-in or line out?
Purists will tell you its always best to use the players headphone out as the line out is bypassing the internal amp section of the source and the output impedance mentioned. I myself use the headphone out always but you’re not hurting anything if the volume is suitable enough.
Can I use a headphone jack as a line out?
So can a headphone output be a workable substitute for a line level output in other situations? Sure, in a pinch it will usually work okay. Headphone amps usually aren’t as free from noise and distortion as good line amps, but in many situations they can be used without significant degradation in overall sound quality.
How to convert line level to mic level?
The 100 Ω output impedance is well below the 2 kΩ microphone input impedance, so it won’t be loaded by the mic preamp. What you need to do is reduce the voltage level, and block any DC. The resistors are set up as voltage dividers which reduce the input level to something managable by the microphone input. The capacitors block the DC.
How are resistors set up to reduce mic level?
The resistors are set up as voltage dividers which reduce the input level to something managable by the microphone input. The capacitors block the DC. How much should you attenuate the signal? It depends on the typical line levels you’ll get from your equipment.
Can a headphone be plugged into a direct box?
But as most Direct Boxes have two 1/4″ jacks wired in parallel, it would be simple enough to make or buy a wye cable to take the left and right outputs of the headphone output, and plug both of them into the same direct box. The headphone output is independent of the power amp output, so you do not need to worry about any interaction there.
What should the impedance of a microphone be?
This attenuates the voltage by about 1000, which should be about right. The 100 Ω output impedance is well below the 2 kΩ microphone input impedance, so it won’t be loaded by the mic preamp. What you need to do is reduce the voltage level, and block any DC.