Contents
How do I connect two Zigbee devices?
The other device act as Zigbee Router. Connect the Xbee module configured as router in its circuit. The Xbee module is connected to the Arduino in the similar manner. An LED is interfaced with the Arduino at its PD2 (pin 4) pin through a pull up resistor of 220 ohms.
How do we configure Zigbee node as coordinator?
Configure XBee Gateway as a coordinator
- From a web browser, open the Home page of your XBee Gateway ZigBee and go to the XBee Network section from the left menu.
- Select the local XBee device for XBee Gateway.
- From the XBee Configuration page, open the Network Settings section.
What is Zigbee end device?
A Zigbee End Device (ZED) provides only basic functionality and cannot send or receive directly with other devices. A Zigbee Router (ZR) passes data between devices and/or the coordinator; it can also run applications. A network can run in either a beacon or beaconless mode.
How to set up the second XBee module?
Click the Write radio settingsbutton . Set up the second XBee module (XBEE_B): Select the second XBee module. Click the Load default firmware settings button . Configure the following parameters:
How to setup XBee as a wireless router?
XBee Wireless Communication Setup. 1 Step 1: Download X-CTU Software. 2 Step 2: Put together your XBee breakout board. 3 Step 3: Configure 1st XBee as a coordinator. 4 Step 4: Configure 2nd XBee as Router. 5 Step 5: Test the configuration.
How to configure XBee modules in transparent mode?
Configure the following parameters: ID: D161 DH:0013A200 DL: SLof XBEE_B (Enter the last eight characters of the MAC address for XBEE_B. Or select XBEE_B and find its SLvalue.) NI: XBEE_A PL: 0 Click the Write radio settingsbutton .
Which is the destination address in XBee _ a?
SLof XBEE_A Defines the destination address (low part) for the message. The value of this setting is the SL(Serial Number Low) of the other module. NI