Contents
How to set up IC 7300 for WSJT X?
Operating
- Turn the IC-7300 power ON.
- Set your PC clock accurately. (
- Select an operating band in the band selection pull-down menu.
- Set the mode to USB, then touch “DATA” to select the “USB-D” mode.
- Set the IF filter bandwidth (BW) to 3.0 kHz for the USB-D mode, as shown below.
Does the IC 7300 need a power supply?
Answer: You need to purchase an external power supply. I use the TekPower TP50SW 50 Amp 13.8V Analog Power Supply. It works nicely with the IC-7300.
What software do I need for FT8?
WSJT-X is the most popular software for FT8. This great program is not only free but versions are available for Windows-based PCs and Macintosh OS, Linux (with pre-compiled Debian, Fedora and Raspbian distros). For details on installing and configuring the software, follow the online WSJT-X User Guide.
Does the IC 7300 have a built in sound card?
The Icom 7300 uses an internal sound card device. Download and install the Windows Icom 7300 USB driver from Icom before attaching the rig to your computer.
What is Flrig?
FLRIG is a transceiver control program designed to be used either stand alone or as an adjunct to FLDIGI. The supported transceivers all have some degree of CAT. The FLRIG user interface changes to accommodate the degree of CAT support available for the transceiver in use.
What band is ICOM 7300?
| General | |
|---|---|
| Frequency coverage RX TX | 0.030–74.800** 1.800–1.999, 3.500–3.999, 5.255–5.405*, 7.000–7.300, 10.100–10.150, 14.000–14.350, 18.068–18.168, 21.000–21.450, 24.890–24.990, 28.000–29.700, 50.000–54.000 * Some frequency bands are not guaranteed. ** Guaranteed range: 0.500–29.999, 50.000–54.000MHz. |
Does ICOM 7300 have Bluetooth?
It is possible however to add a very small Bluetooth transmitter to the 3.5mm headphone jack and then use a pair of Bluetooth headphones around the shack. …
What are the settings for WSJT-X for the IC-7300?
Set Windows audio recording device so that the green RX bar in WSJT-X is around 30% on a quiet band/frequency. Set default format to 1 channel, 48000 Hz. Label the audio devices as “IC-7300”. When transmitting, adjust Pwr slider in WSJT-X until it begins to tickle the ALC meter.
How to get the ICOM 7300 on the air with FT8?
Important: Use something for time sync. I use NetTime. In WSJT-X there are just a few configuration settings to get the Icom 7300 on the air with FT8. In the software, under File and Settings, on the General Tab enter your callsign and grid square. On the Radio tab select the Icom 7300 for the Rig. You’ll need to know your COM port number.
What is data mode on ICOM IC-7300?
By default, DATA mode ON is set to ACC, this can be changed in the settings menu to USB. So, out of the box hooked up with USB, the IC-7300 does not transmit your digital mode signal.
Do you need a USB cable for an IC-7300?
Yes, you only need a USB2 A to B cable. The IC-7300 already has an integrated sound card, for audio signal transmission, and an integrated serial port for remote control, both of which are connected to computer using the USB2 B port at the back of the radio.