Contents
Are caliper pins interchangeable?
They are interchangeable. One has a small rubber bushing on the end, the other does not.
Are brake calipers supposed to slide?
Most cars are fitted with a floating brake caliper system. It is by nature free to move laterally by about an inch or so and seeing this could understandably alarm those unfamiliar with the system. Floating caliper movement is normal behavior. You can easily check if the caliper is secure.
How do I know if my caliper slide pin is bad?
Here’s how you can tell if your brake caliper has gone bad:
- Pulling to one side. A seized brake caliper or caliper sliders can cause the vehicle to pull to one side or the other while braking.
- Fluid leaks.
- Spongy or soft brake pedal.
- Reduced braking ability.
- Uneven brake pad wear.
- Dragging sensation.
- Abnormal noise.
What do caliper slide pins do?
Their job is to keep the water, sand and dirt away from the slide pin bores and helps keep the special grease inside. When pin boots don’t keep the bad stuff out anymore, the pins can seize. Most of the time, this condition causes the brake to have trouble releasing or letting go when you drive off.
Why does one caliper pin have rubber?
A Theory: The Brake Caliper Slide Pin Rubber Is an Anti-Rattle Device. The sleeve provides additional friction, which prevents the brake caliper from rattling/chattering within the confines of the caliper bracket.
What happens if you don’t lube caliper pins?
Over time, the slide pins lose their lubrication and don’t slide the calipers so well. This lack of lubrication causes a few things to happen. While there is a rubber cover protecting the slide pins, they experience brake dust and rust buildup, which hinders the calipers from sliding.
Should you grease caliper pins?
2. Not lubricating the guide pins: Caliper guide pins on floating calipers should be cleaned in solvent and new grease should be applied. The grease is under extreme heat and pressure so always use a caliper specific grease. NEVER put a torn boot back on a car.
Can you put too much grease on caliper pins?
Because the excess lubricant can melt or some chemicals can flash off. If excessive lubricant finds its way onto the caliper piston’s boot, the lubricant will attract metal particles that can destroy the rubber. too much!!!!! Shims need only a small amount of lubricant.