Why does my EFI fuse keep blowing?
There are several EFI components protected by that fuse and any one of them can cause the fuse to blow, my bet is on the fuel pump needs replaced as it draws the most current and will draw more current as it ages. One other thing can cause it is a short to ground in the wiring, which is rare.
Why does my PCM fuse keep blowing?
Check the oxygen sensor wiring for melted wires against the exhaust. If that is ok then unplug the harness on the top of the transmission then see if it blows the fuse. The internal wiring could short against the inside of the pan or the case of the transmission.
What is the EFI 2 fuse?
EFI 2 controls the fuel pump ecu Toss a 30amp sucker in there.. you should be fine! good luck!
What is EFI No 2 fuse?
EFI#2 fuse powers the MAF, oxygen sensors and evap solenoids.
What happens when fuse blows?
Blowing a fuse or tripping a circuit breaker is a common issue, especially if you’re a multitasker. If you overload a circuit, your system will cut off the electrical flow to prevent your wires from overheating and causing circuit damage or fire.
What happens if ECU fuse is blown?
If an electrical wire gets burned or damaged, the cables pointing to the ECM is going to short-circuit. Once that happens, a power surge can result, and if it the exceeds the fuse’s limitations, the fuse is going to blow. Once you have checked all those spots, check the wires and the coil on the back of the engine.
Why does my EFI fuse keep blowing randomly?
EFI fuse blows randomly. I am beating my head in with this issue. EFI fuse blows randomly, I have found no patter. When it blow, it will keep blowing them and not start. I have to disconnect the battery first and then replace the fuse. Then it will run a good while till it blow the fuse again.
Why does my battery keep blowing the fuse?
When it blow, it will keep blowing them and not start. I have to disconnect the battery first and then replace the fuse. Then it will run a good while till it blow the fuse again. Looking for a short but I can’t find one but the battery thing makes me think it is something deeper.
Where are the fuses on a Toyota Ricks?
2) The wires near the EGR vacuum switching valve (VSV) located under the intake manifold. 3) Wires pinched between the intake manifold and the cylinder head. 4) Wires pinched anywhere along the valve cover. 5) Check injector wiring for any pinched locations.