How do I fix error P0125?
How do I fix trouble code P0125?
- Verify the coolant level.
- Check the thermostat to ensure it is opening properly.
- Inspect the coolant system for leaks and bad wiring.
- Use a voltage meter or infrared thermometer to continue diagnosing the problem.
- Replace faulty components.
What does OBD code P0125 mean?
P0125 is the OBD-II generic code for the engine computer, or Engine Control Module (ECM), not detecting enough heat in the cooling system before the fuel management system can take control. The ECM has a predetermined value after you start your vehicle to expect a certain coolant temperature.
How do you test an overheating sensor?
Submerge your temperature sensor in the hot water and wait a few seconds to let your multimeter take a reading. Write down your reading so you can easily reference it. A hot water reading should give you around . 25 volts.
What does closed loop fuel control mean?
In a nutshell, closed loop is where the engine operates with a feedback loop. A sensor closes the loop. The sensor in question is a lambda sensor, also known as an oxygen sensor or air/fuel ratio mixture sensor. In closed loop mode, the engine listens to the lambda sensor to adjust fuel/air mixture.
What is diagnostic trouble codes on cars?
A DTC, short for Diagnostic Trouble Code, is a code used to diagnose malfunctions in a vehicle or heavy equipment. While the malfunction indicator lamp (MIL)—also known as the check engine light—simply alerts drivers that there is an issue, a DTC identifies what and where the issue is.
Where is the engine temperature sensor located?
The Engine Coolant Temperature Sensor can be located in a few places, depending on the vehicle and its manufacturer. It is most often located close to the thermostat of the cooling system or inside of it. The cooling system is located beneath the air intake pipe and behind the right cylinder.