Contents
How do you wire rear door speakers?
Wire the rear speakers in exactly the same way as the door speakers, plugging positive speaker wires into positive ports, and negative wires into negative ports. Replace door panels in the front, and grilles in the rear.
How do you hook up an aftermarket speaker to a factory radio?
The best way to connect it to a factory system is to tap into the stereo’s speaker outputs for the amp’s input signal. Then send the amp’s outputs back to the stereo’s harness, and on to the speakers through the factory wiring.
Do I need an amp for aftermarket door speakers?
A: In most cases, yes. Aftermarket speakers will certainly sound better with a little more juice, but most of our speakers will sound just fine with factory power. Low-efficiency speakers can sound great, but they’ll need a high-powered receiver or amplifier for energy.
Can you connect a subwoofer to a factory stereo?
In techie terms: …it takes amplified speaker level signals and converts them into high quality preamp signals that can be fed into an amplifier. So now you know – it’s definitely possible to install a subwoofer and amplifier to your factory system, and still have it sounding good.
How can I Make my Car Stereo work?
Turn on the stereo system. Verify all speaker channel connections are accurate and secure. If an amplifier is installed, verify that it is connected correctly and has power. If the car stereo receiver has an audio Attenuation ( ATT) feature, make sure it is turned off.
Where do the speaker wires go on a car stereo?
The wires would run from one black connector to the other (the right side of the photo below). But since we’re using an external amplifier for the speakers, the speaker wires from the car get diverted to the amp — that’s the bundle of wires on the bottom plug heading left to the amplifier. The speaker wires from the new stereo aren’t used.
How do I connect my surround back speakers?
If connecting only one surround back speaker, connect it to the L (+/-) terminals. If you have an additional front speaker system, connect it to these terminal. In this case, select a speaker pattern that does not have surround back and front high speakers.
Is there a subwoofer option on a car stereo?
If the car stereo receiver has an audio Attenuation ( ATT) feature, make sure it is turned off. Some systems offer a subwoofer ( SUB) volume setting that can be edited through the menu of the car stereo. If the Sub/Rear option is set to SUB-OUT, there is no option to fade from front to rear.