Why does my bandsaw blade bend?
When the band saw cuts crooked, a dull blade, improper feeding, loose blade tension or not using a work piece guide could be the cause. Check blade tension by pressing in on the side of the blade using a gloved finger. Tighten blade tension if you can easily push the blade in more than a 1/4-inch.
Can you fix a bent bandsaw blade?
Most experienced woodworkers will recommend replacing a bent or kinked bandsaw blade. You could also try and use a pair of gas pliers to straighten out the blade. This could allow you to finish what you were working on until you can replace the blade if you don’t already have any replacement blades in the shop.
What does resaw mean on a bandsaw?
Bandsaw Resawing from the beginning: resawing is cutting a sawn plank of wood into thinner planks on a bandsaw. Thus the cut runs through the plank’s width, which distinguishes bandsaw resawing from ordinary bandsaw rip cuts where the blade runs through the stock’s thickness.
How to stop a wandering band saw blade?
The fence alignment (which is pretty constant) fights the blade alignment (which is pretty variable), and you end up with trouble. Instead, use a simple shop-made guide (a scrap of wood) that provides a single pressure point right at the edge of the cutting teeth on your blade. You can set this for the thickness of the cut.
Why does my band saw wander off course?
Regardless of what size blade I use or the thickness of the material I’m cutting, the blade wanders off course. I’ve given up trying to resaw with it because, even with a jig and 3/4 inch blade (the widest my saw will take), I can’t cut pieces with a consistent thickness.
Can a rip fence be used on a band saw?
Even if you get it “just right,” the rubber tires on the wheels will likely change over time, and the camber angle will change with it, throwing your careful adjustments off. Using a rip fence on a band saw, like a rip fence you might find on a table saw, will nearly always cause grief – especially when you try cutting long boards.