Contents
What order should I sand?
Do NOT start sanding with very fine sandpaper on unfinished wood. Prepare the surface by using medium paper first, and then proceed to finer grades. On most raw woods, start sanding in the direction of the grain using a #120-150 grit paper before staining and work up to #220 grit paper.
Which edge goes first on router?
Proper router feed direction is critical to smooth cuts. It’s best to rout end grain first. Then, if splintering occurs at the corners, the splintered area on the edge will typically be cleaned up when you make a pass along the edge grain.
How do you round edges of wood with a sander?
You need to move or rub the sanding block along the length of the edges and end at a 45-degree angle. Once you reach close to your desired facet, use the sandpaper on the palm of your hand, and round it over slightly. Your hands will bend the sandpaper and contour to give you a rounded shape.
What’s the best way to sand router edges?
Required Tools for this router edge guide 1 Clamps 2 Dust mask 3 Hearing protection 4 Hot melt glue gun 5 Orbital sander 6 Router 7 Safety glasses 8 Sanding block
What’s the best way to sand cross grain wood?
When sanding cross-grain, stop just shy of the surface, as shown at right. When easing a corner, begin on the long-grain edge, and take a series of uninterrupted pulls that fully round the corner and finish with the block in contact with the end-grain edge.
Which is the most neglected part of sanding?
Treat the sanding phase of a project with as much attention as you give to making accurate cuts. Probably the most neglected parts are wide faces, say the top of a table or the sides of a bookshelf. We might spot sand a few glaring problem areas, then just give the rest a quick once-over.
What should I do if I sand my house with a random orbit?
If you are really prone to doing this, you can run some tape along the edge to protect it, it’s probably fine to just avoid sanding that close. You’ll have to sand the corners by hand anyway, and it will just take a little longer to hand sand those inside edges.