Contents
Can you run plywood through a jointer?
With the addition of a simple shop-made fence, you can easily edge joint on your table saw. Remember that man-made materials like plywood can be hard on steel jointer knives – but not on carbide table saw blades.
How thick should a mortise be?
Cutting the Mortise. The mortise depth should be roughly three times the thickness of the tenon. It can be cut in several ways, among them the traditional approach of using sturdy mortising chisels and a mallet to chisel out the hole by hand.
Is it possible to plane plywood?
Can You Thickness Plane Plywood? The short answer to this is, yes, you can thickness plane plywood.
Can you chisel plywood?
Whether you are carving out a new design or board, using chisels on plywood is an art. A sharpened chisel can be used on plywood to square it up or put some finishing touches on a joint. Thin plywood can be entirely cut with a chisel, although not a recommended method.
How do you hide plywood joints?
Flip the first piece of veneer over and run a bead of glue along the center at the back of the piece from one end to the other. Line the edging up over the first seam and press it into place by hand. Run your hands up and down over the entire surface so it can adhere in place to the plywood underneath.
What size should my mortise and tenon be?
Over time craftsman have developed general rules for properly sizing their mortise and tenon joints, they are: Tenon length: A tenon’s length should be at least five times its thickness. So, a 1/4″-thick tenon should be 1-1/4″ long.
How to make mortise and tenon joints using hand tools?
There is already a question about making mortise and tenon joints using hand tools. It would be nice to also catalog the various ways of making mortise and tenon joints using power tools. Wherever a jig is required for safety or quality of fit, please also include a photo or link to the type of jig mentioned.
What kind of tool do you need to make a mortise?
In order to square them up, you’ll have to use a hand tool like a chisel. As mentioned in other answers, a matching long tenon can be made with a table saw, a dado blade, and a tenoning jig. To make the mortise, you can get a dedicated mortising machine:
Can a table saw cut the face of a tenon?
At the very least you can cut the shoulders of the tenon on the table saw, giving you an nice square cut to work with. There are also tenoning jigs for the table saw which you cut the face of the tenon with one pass, so a full tenon would be 4 passes.
Can a hammer and chisel be used for mortise?
The mortise as the other have mentioned can be done with a hammer and chisel, and drilling consecutive holes to the correct depth will help speed the process up. If you have a drill press that will make the job easier and you can be very accurate on how deep you drill all the holes.