Contents
What is the advantage of a mitered corner joint?
The miter joint has two signal advantages over a butt-corner joint: First, no end grain shows, making for a more regular and attractive joint; second, the surface for gluing is increased. Miter joints may also be fastened with nails, screws, dowels, or other mechanical fasteners.
Should I cope My crown molding?
Although it takes some practice to cope well, most pros think it yields a better corner. Some people think a mitered inside corner will perform just fine. Others fear the joint will open up as the wood expands and contracts throughout the year.
What is COPE joint?
Coping is a wood joinery technique that ensures professional looking results. In a coped joint, one side is square cut and rests in the corner, while the other piece is shaped to fit as shown at right. Why make coped joint.
What is a cope joint?
Why is crown molding so difficult?
The hardest part of installing crown molding is cutting the corners. You can’t do it like any other trim pieces because the molding sits at an angle between the wall and the ceiling (Image 1). Using a coping saw (Image 2) is the easiest way to cut the corners because a coped joint is tighter than a mitered joint.
Do you use mitered or coped joints on wood?
For do-it-yourselfers, coped joints can be tricky to cut perfectly. If you attempt coping, make sure to practice your technique on scrap wood. If you get good results, coping is the way to go. If you find coping difficult, you will be best served by using mitered joints for your baseboards and coped joints only when absolutely necessary.
Which is better a miter or a cope?
Repeat the process for the opposite miter. Coping is better than mitering at inside corners. But on tall baseboards, cutting the long, straight section of the cope with a coping saw is difficult, and the cut is usually wavy. Instead, start the cope as usual (Photo 1).
Which is better mitered or coped baseboard joinery?
Coping is the traditional method of baseboard joinery and is considered a mark of craftsmanship. For this reason, it is often preferred for work with historic or period moldings. On the downside, coped joints take more practice and skill than mitered joints.
What’s the difference between coping and mitering Crown?
Some people think a mitered inside corner will perform just fine. Others fear the joint will open up as the wood expands and contracts throughout the year. Mitering crown is for outside corners, furniture and cabinets. It is simply the best practice to cope inside corners on crown installed at the wall/ceiling.