Contents
Can you joint both edges?
You can’t make both sides parallel by running both sides across the jointer. Your process is correct. If I’m doing a panel glue up I joint both edges, but I joint the second side after it has been ripped parallel.
Can you use a hand plane as a jointer?
A planer can be used as a jointer by following a few woodworking tricks. Woodworking jointers and planers are used to mill wood so they can be used to build furniture and other projects to correct dimensions.
When jointing the edge of a crooked board what Edge goes down?
How you orient a board depends on its warp (Figure 2) and the slope of its grain. For stability when feeding, place the concave face or edge against the jointer tables. When face-jointing, this means you should orient the cup or bow downward. When edge-jointing, the crook should be at the bottom.
What’s the best way to joint a board?
When jointing edges by hand, in addition to the physical planing work it’s important to first mark out your boards well, on both faces and both ends, and then work down to your line. Even with marked/gauged lines to work to planing long board edges flat and square to the face is fairly challenging.
What’s the easiest way to joint an edge?
Teaching someone to cut dovetails is easy. Teaching them to joint an edge for glue-up with a handplane is something else. If you don’t believe me, consult Joseph Moxon, who wrote the first English-language book on woodworking.
Do you need a straight iron for edge jointing?
Anyway, this little block of wood clamped to his plane makes edge-jointing a breeze. You don’t even need to have a straight iron. If your iron is cambered you can adjust it laterally to make a square cut. I told the student to submit the jig to Popular Woodworking Magazine as a “Trick of the Trade” and he did.
Which is cheaper a joiner or a hand plane?
The hand plane will need a bit more practice than a joiner but it is significantly cheaper (assuming to don’t ruin lots of wood…) The simplest method is with an edge guide made of 1/2 plywood clamped to the piece or screwed to the piece and a skill saw.