How to connect A6 GSM GPRS module with Arduino Uno?

How to connect A6 GSM GPRS module with Arduino Uno?

How to connect A6 GSM GPRS module with Arduino and also work with “AT” commands. How to connect A6 GSM GPRS module with Arduino and also work with “AT” commands. This is A6 GSM/GPRS module. In this tutorial, we shall learn how to connect the module with Arduino Uno and also work with “AT” Commands. This A6 module has the following features.

How to test the A6 GPRS module at commands?

Send and receive GPRS data (TCP/IP, HTTP, etc.).- Be used to test the Ai-Thinker GPRS A6 module- Pin pitch: 2.54mm- Onboard antenna interface: SMA and IPX If you connect this with arduino uno for AT commands, you need only 4 wires. I decided to use four difference colored wires for easy understandings.1st insert a micro – sim card to A6 module

How to work with AT commands on Arduino?

WireA6 ModuleArduino UnoREDVCC+5VBLACKGNDGNDORANGEU_RXDPIN 2YELLOWU_TXDPIN 3 Once the wiring is completed, you can start programming. How to work with AT commands? After Uploading codes, run the serial monitor.Now type AT and press enter.

What is the ATA 7 command for GSM?

ATA 7) ATH – This command is used to disconnect remote user link with the GSM module.

How to send SMS using A6 GSM GPRS module?

Eg: Type ATD+123456789 then enter (your phone number) HOW TO SEND SMS? Type AT+CMGF = 1 then enter “ Answer should be OK” Then Type AT+CMGS = “+123456786” then enter (your phone number) I am an accountant in profession but, I would more prefer to work with electronics based innovations.

How many pins does the A6 GSM module have?

The A6 GSM module has total 24 pins that interface it to the outside world. The connections are as follows: VCC supplies power for the module. Connect this to any external power source rated 5V 2A. GND is the Ground Pin and needs to be connected to GND pin on the Arduino. MIC± is a differential microphone input.