Contents
How do you read a DHT11 sensor?
The DHT11 sensor has this pin configuration: The sensor consumes 0.3 mA when measuring the humidity and temperature and 60 uA in standby mode. It has an accuracy of +/- 1% for the humidity and +/- 1˚ C for the temperature. The sensor can output data at a maximum sampling rate of 1 Hz (i.e. once per second).
What’s the difference between DHT11 and DHT22?
Here are the main specifications and differences between these two sensors: The DHT22 is the more expensive version which obviously has better specifications. Also the DHT22 sensor has better humidity measuring range, from 0 to 100% with 2-5% accuracy, while the DHT11 humidity range is from 20 to 80% with 5% accuracy.
What is the difference between DHT11 and DHT22 sensor?
Which is more accurate a dht11 or dht22 sensor?
The DHT11 has a smaller range and it’s less accurate. However, you can request sensor readings every second. It’s also a bit cheaper. Despite their differences, they work in a similar way, and you can use the same code to read temperature and humidity.
What does it mean when your DHT sensor says ” failed to read “?
If you get an error message in your serial Monitor while reading the temperature and humidity from the DHT11, DHT22, AM2302 or AM2301 sensor, follow the next steps to see if you can make it work. If your DHT11 / DHT22 sensor returns the error message “Failed to read from DHT sensor!” or the DHT readings return “Nan”:
How to read temperature and humidity from dht11 sensor?
This article shows how to make ATtiny13 to read temperature and humidity from DHT11 sensor and log this information using a Software UART. What you need is connect DHT11 DATA-pin to PB0 and RX-pin of USB to serial adapter to PB3 of ATtiny13. You also need to connect sensor to power supply (3.3V or 5V).
Can a DHT sensor be used with Arduino?
The DHT11 and DHT22 sensors provide an easy and inexpensive way to get temperature and humidity measurements with the Arduino. The wiring is very simple – you just need to connect the DHT data pin to an Arduino digital pin. Writing the code to get temperature and humidity is also simple thanks to the DHT library.