Contents
Why is the filament not feeding?
The main causes that lead to a 3d printer not feeding filament are a clog along the extrusion path, a damaged PTFE tube, incorrect retraction settings, unwanted filament tension, too high (or too low) extrusion temperature, a clogged nozzle or worn-out driver gear.
Why is my 3d printer not extruding properly?
If the printer is not extruding enough, the extruder may be clogged. If this happens, check that the filament is clean and the spool is dust-free. If there is a lot of dust on the reel, it can block the extruder as it accumulates inside the nozzle.
How do you make a filament feed smoother?
If your filament is not feeding properly, you should reduce retraction settings, check your PTFE tube for clogs or damage near the ends, unclog your nozzle, check the teeth on your extruder for wear, adjust idler pressure on your feeder gear and check your extruder motor for instability.
How do you unblock a 3D printer nozzle?
Simply heat your hot end up to the printing temperature of the material that’s involved in the clog. Using a pair of pliers, carefully insert the needle or guitar string into the nozzle opening and move it back and forth, essentially breaking through and removing the clogged material.
How do I make my top layer 3D print better?
The top layer exists out of multiple solid layers that are attached to each other. To ensure a smooth top layer, it has to be thick enough. As a rule of thumb, you can use a height of 0.75mm for the entire top layer. Depending on the printing height, you will therefore have to use several layers to reach a 0.75mm top.
How can I make my 3D printer smoother?
The Ultimate Smooth 3D Print A well-known technique for smooth ABS 3D prints is to place the print in a sealed container filled with acetone mist. The acetone interacts with the ABS and melts the plastic in a slow and controlled way to create a super smooth model.
How to disassemble a Monoprice mini V2?
This article will help you with disassembling the Monoprice Mini V2 Extruder assembly in case there is need to remove a clog, replace the nozzle or internal PTFE Tube. Please contact Monoprice Technic…
How to remove filament from Monoprice mini nozzle?
Return to the Home Screen and select the Move menu item. From the motion control panel, select the Extruder menu item. Turn the dial to run the filament down the tube until a small section of it is projecting out of the end of the Bowden tube detached from the print head.
Is the Monoprice mini a good 3D printer?
The Monoprice Mini is an awesome 3D Printer. I’ve been using it for sometime now and this printer has completely convinced me to stop using my only other printer that I’ve had over the past 2 years. However, like with all machines, you will run into rough weather – some of your own making, and some that are part of buggy product designs.
How to unclog MP Select mini 3D printer?
Next, change the nozzle temperature down to around 140 degrees and allow the printer to reach temperature. Once the temperature is reached, maintain pressure on the filament for at least 2 minutes.