Contents
What is a LoRa shield?
Lora Shield is a long range transceiver on a Arduino shield form factor and based on Open source library. The Lora Shield allows the user to send data and reach extremely long ranges at low data-rates.It provides ultra-long range spread spectrum communication and high interference immunity.
How do I use LoRa Gateway?
Connect through Ethernet
- Just fill a static IP Address according to the IP address of the router you want to connect. Please note that the LoRa gateway and the router must be in the same network segment, otherwise the connection will fail.
- By default, the IP Address of the LoRa Gateway’s Ethernet is 192.168. 10.10.
What is a LoRa network?
The LoRaWAN® specification is a Low Power, Wide Area (LPWA) networking protocol designed to wirelessly connect battery operated ‘things’ to the internet in regional, national or global networks, and targets key Internet of Things (IoT) requirements such as bi-directional communication, end-to-end security, mobility and …
What is the use of LoRa Gateway?
LoRaWAN Gateways are the link between the source of data – sensors in the environment – and people. They enable scale for the Internet of Things and are a key element in the chain that enables better visibility, reduction in costs, reduction in resource inputs, improved safety and better decision making.
What can the dragino Lora shield be used for?
The Dragino LoRa Shield is a long range transceiver on a Arduino shield form factor and based on Open source library.The LoRa Shield allows the user to send data and reach extremely long ranges at low data-rates.It provides ultra-long range spread spectrum communication and high interference immunity whilst minimising current consumption.
How to register Arduino Uno with dragino Lora?
The device node, composed by an Arduino Uno + Dragino LoRa Shield, once it is correctly registered in TTN collects the LDR data and send them through LoRa. To register the device into TTN, we have to browse the console, click on Application and, if it is necessary, on Add Application.
What’s the latest version of Lora Shield for Arduino?
LoRa Shield v1.3: Remove 5v to 3.3v LDO, use 3.3 directly from Arduino +3.3v pin. LoRa Shield v1.4: Add 3 resistors R9/R10/R11. Purpose is to provide possibility to change the Arduino pin connect to LoRa CS pin, so Arudino can easier to connect to multi SPI devices. by default, R9 is populated and R10/R11 is not populated.
Why do I need a Lora CS pin for arudino?
Purpose is to provide possibility to change the Arduino pin connect to LoRa CS pin, so Arudino can easier to connect to multi SPI devices. by default, R9 is populated and R10/R11 is not populated. So LoRa CS is connected to Arduino D10.