Contents
Can I use dado on DWE7485?
Despite the smaller saw blade, the DWE7485 weighs 10 lbs. Like the other DeWALT job site saws, you cannot add a dado stack. This isn’t exclusive to this model, but that’s a deal breaker to a lot of woodworkers.
What size dado do I need?
8-Inch vs. 10-Inch. There are a couple of reasons why you don’t need a 10-inch dado blade set. Since dadoes rarely need to be cut deeper than about 1 1/2 inches, an 8-inch dado blade set will be large enough to cut most dadoes and rabbets.
Is arbor the same as bore?
What Is the Arbor Hole? The center hole is technically considered the arbor hole. It’s essential to understand the connection between the bore and the shaft. You’ll need to know the shaft’s diameter when you’re selecting a blade, as a precise fit between the two will ensure steady spin and cut efficiency.
Can I use a dado blade on DW745?
No, we do not recommend using a dado blade on the DW745 Table Saw. There is a misprint in the DW745 type 2 manual that says you can use a dado blade, this information is incorrect and is being revised. See the attached Powerpoint presentation regarding the error in the DW745 ty 2 manual. 13 of 13 found this helpful.
Can a stacked dado blade be used on a short Arbor?
Many small- to medium-size table saws have relatively short arbors that do not safely accommodate a full stacked dado blade set. This isn’t a problem when using a single saw blade, but when trying to use a 3/4-inch stacked dado blade, there isn’t enough thread to allow the nut to be safely threaded onto the arbor.
Can a dado blade be used on a 10 inch table saw?
Copyright: Freud. As long as the diameter of the arbor hole on the stacked dado blade set matches the arbor diameter of your table saw or radial-arm saw—and the arbor is long enough for a dado blade—you can use an 8-inch dado blade on a 10-inch table saw. There are a couple of reasons why you don’t need a 10-inch dado blade set.
Can a blade be too big for an arbor?
A blade with too large of an arbor hole simply can’t be balanced properly for use. Conversely, if your blade set has an arbor hole too small for your arbor, resist the temptation to drill out the arbor hole, as you may not only put the blade out of balance, but the heat from drilling may alter the temper of the blade.
Can a 5 / 8 inch blade be used on a 10 inch saw?
However, there are a few rare instances where a saw doesn’t have a 5/8-inch arbor or the blade set doesn’t have a 5/8-inch arbor hole. A blade with too large of an arbor hole simply can’t be balanced properly for use.