Contents
Can you Desolder a PCB?
Even the highest quality components fail from time-to-time. That’s why desoldering is so important for those who manufacture, maintain or repair printed circuit boards (PCBs). It’s portable, easy to use, one of the most common tools used for PCB repair, and doesn’t require constant maintenance like other tools.
Is flux needed for desoldering?
When desoldering, you should apply flux to whatever the solder is supposed to wet to. If you are using a copper desoldering braid, then apply a bit of flux to it.
How do you remove a diode from PCB?
Grasp one of the diode’s leads with the long-nose pliers and wiggle slightly to free it from the board. Repeat for the remaining lead until it breaks free of the board. Maintaining your grip on the pliers, carry the diode from the board and gently drop it onto your work area.
How many times can you Resolder a PCB?
Re: How often can you desolder and resolder a board/pcb? If you are using desoldering gun, then it can pretty much last as long as you want. If not, then 1-2 desoldering probably will screw up the plate.
How do I remove something from my motherboard?
Open your machine. First, you need to remove the side panel from the computer case. The side panel is usually held in place by several screws, or held in place with a bracket or clamp of some kind. Remove the fasteners securing the side panel, and carefully pull it off.
What is a desoldering tool?
A desoldering pump, colloquially known as a solder sucker, is a manually-operated device which is used to remove solder from a printed circuit board. When triggered by pressing a button, the piston springs up, creating suction that sucks the solder off the soldered connection.
Where does flux go?
Flux may be solid, pasty, or liquid in form depending on how and where it will be used. For hand soldering, flux can be applied by a flux pen or is usually in the core of the solder wire that most technicians use.
How do you use flux?
Use a small paintbrush or your fingers to scoop up a small amount of soldering flux. Spread the flux over the area you will be soldering, making sure to cover the wires fully. Wipe any excess flux off your fingers or brush before soldering. Soldering flux is only corrosive once it is heated up and in its liquid form.
How to remove an electronic component from a PCB?
In fact, there are many techniques to remove an electronic component from a PCB. Here are the best known: Brutal: the heat gun A very simple technique consists in using a heat gun to heat the area where the component is located.
Is there a way to desolder an electronic component?
Solder cools down too fast to try to heat each contact one after the other. Naturally, there are work stations dedicated to component desoldering. But if you have one, your line of work is probably about electronic boards rework, and so you won’t be much interested by the remainder of this post.
What’s the best way to desolder a circuit board?
Wick that is too thin won’t remove enough solder and requires you to trim and remelt the solder over and over. Wick that is too wide takes longer to heat and may interfere with other components on the circuit board. Choose a solder wick width that closely matches the size of the contact area.
Which is the best desolder tip for PCBs?
Personally, I like the D-tips (as explained best in JColvin91’s Instructable: Uses of Different Desoldering Tips) since I do mostly “rough” soldering jobs. The B-tips are great for soldering components to PCBs, but transfer heat poorly and wear out faster from my experience. Step 2: Build (or Buy) a PROPER Circuit Board Holder!