Contents
Can you tighten throttle cable?
In order to fix a loose or tight throttle cable, you’ll need to turn this nut. Place the open ended wrench over the throttle body adjustment nut, and turn the nut either clockwise or counterclockwise until there is about 1/4 inch play in the tension of the throttle cable.
How loose should my throttle cable be?
The accelerator cable tension is usually set so that 2-3mm of free play is present in the throttle grip. Once the correct tension has been applied, the lock nuts should be snugged and any dust covers should be slid back over the adjusters. Cables can be adjusted using the appropriate size wrench.
How do I know if my throttle cable is loose?
Signs of a bad accelerator cable
- The pedal feels stiff or hard to depress.
- The pedal sticks and does not release normally.
- There is slack in the pedal’s movement.
- There is a rough or abnormally low idle.
- The engine stalls.
- There is a delay in response when you push the pedal down.
What happens if throttle cable is too loose?
When there is excess slack or the cable is too tight, this can cause intermittent delays in throttle response relative to pressing down on the accelerator pedal. This can also result in the opposite effect as well, in that the excess slack can create a delayed throttle return response.
What happens if throttle cable breaks?
When the gas pedal is pressed, the cable is pulled and opens the throttle. If the cable breaks, or comes out of adjustment far enough, it can affect the drivability of the vehicle to the point where the car will not be drivable until the problem is addressed.
How do I stop my throttle cable from fraying?
Super Glue will stop the cable from fraying too. One drop on the end, and hit it with activator.
How do you adjust the throttle valve cable?
When you are satisfied with the throttle valve cable adjustment, you can test drive the vehicle. Drive with light to moderate acceleration and ask your helper to note down and check the shift feel and the MPH of the shift points. Compare these to the original readings and any specifications provided in the owner’s manual for your car.
Where do you put choke control cable in a car?
Place the choke control cable under the intakemanifold from the front of engine (front pullchoke). Insert the cable bowden wire into thechoke control (front or reverse pull). Thenplace choke cable under the cable clamp.
Where do you find the throttle linkage on a Honda Accord?
Step 2: Locate the throttle linkage. Before you can make any adjustments, you will need to locate the throttle valve adjustment location and the throttle linkage. Pop the hood and look for the intake piping. Follow the piping to the intake itself. You will find a series of linkages and cables mounted on the intake.
What happens when the throttle valve cable is out of specification?
When the throttle valve cable is out of specification, the transmission can shift early, shift late or not shift at all. Before the throttle valve cable can be adjusted, the transmission must be in good working order. First, you will need to find out if the transmission is faulty or if the transmission just needs to be adjusted.