Contents
Do all car stereos have the same connectors?
All aftermarket car stereos can use the same car stereo wiring harness, but it all depends on what the owner of the vehicle wants to do for one main reason.
Where do I connect the blue wire on a car stereo?
Simply connect another piece of blue primary wire to the blue wire in the wiring harness and run the primary wire back to the amplifier to terminate in the remote turn on terminal. To connect wire to wire, an appropriately sized butt connector or other style connector can be used.
What wires are for what on a car stereo?
The right-front speaker wires are gray, left-front speakers are white, right-rear speakers are purple, and left-rear speakers are green. Ground wires are black, antenna wires are blue, and amplifier wires are blue with a white stripe.
How to connect stereo wires to ignition switched 12V supply?
I have the fascia adaptor, aerial adaptor and PC2-85-4 ISO lead. The ISO lead has loose yellow and red wires which need to be connected to 12v supplies (red to ignition switched, yellow to lighting circuit). The stickied ‘Everything you need to know’ post mentions this but assumes you know how to do it!
What kind of wire do I need to hook up a car stereo?
Power connections: Cut a +12V wire (yellow) and a ground (black) wire from the main connector. Strip the insulation to leave about 3/8″ to 1/2″ bare wire. Use a crimp connector, solder, or another connector type to join the power supply’s +12V output (yellow) to the radio’s +12V battery wire (yellow).
How to add an amplifier to your car stereo system?
Connect your remote wire to a 12v switched source that only powers when the car is running and run that down with your other wires to your amp and connect that to the remote wire input on your amp. Run your 12v batter wire from your battery to your amplifier.
How do you hook up a car radio to a power supply?
To connect a car radio to a power supply you’ll need to do the following: Ground: Connect the radio’s ground wire (black wire) to the (-) power supply output Main power: Connect the radio’s +12V battery wire (usually the yellow wire) to the (+) power supply output