Contents
Do you need a relay for lights?
So in short if you do not properly wire the light bar to a battery and use a correct amperage switch which will keep the light bar on it’s own independent circuit a relay is unnecessary. However if you tap into the high beams or another lower voltage switch then you will need a relay to avoid an electrical fire.
Do LED headlights need a relay?
LEDs Need Additional Equipment Unlike standard xenon or halogen bulbs that can be used on a plug-and-play basis (meaning you can unscrew the old bulb and replace it with a new one), LEDs require additional components such as a relay or heat sink under the hood.
Do you need a relay for LED lights?
For anything above 30W we recommend installing a relay. If you do not install a relay and use a switch, you could end up overheating the switch, melting the wires, and reducing the current that is getting to your lights, making them less bright. The relay will have 4 points on it, marked 30, 87, 85 and 86. That is kind of cryptic, isn’t it?
What kind of wire do you need for a relay?
In this case, you need to wire the dash switch in between the trigger current, i.e. the line you spliced off your high beam wire or your backup light wire. With our wiring harness, all you need to do is cut the wire coming from the switch to the 30 prong on the relay, and wire it to your high beam lead or your backup light wire.
How are two relays used to activate a light bulb?
It is possible to use Two relays to create a Normally Closed condition. This sample demonstrates how a relay can be used to activate a light bulb. When the relay turns on, the light comes on. Only one power wire is switched with this sample using the COM (common) and NO (normally open) connections of a relay.
How do you connect a relay to a parking light?
For fog lights: connect the 12 volt positive lead to the positive wire on the parking lights. connect the ground wire from the relay to the high beam positive wire so the fog lights will turn off when the highs are on. For driving or roof lights: connect the positive lead to the high beam positive wire, and the relay ground to the chassis.