Contents
Does Stlink provide power?
NOTE: ST-LINK/V2 could supply the target with 3.3V via pin 19 of the 20-pin connector. STLINK-V3 can only supply the target with 5V power AND the 5V power appears to be connected to VCC of the target by default!
What is St Link v3?
The STLINK-V3SET is a modular stand-alone debugging and programming probe for the STM8 and STM32 microcontrollers. It is composed of a main module and a complementary adapter board. The SWIM and JTAG/SWD interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board.
How does the St-Link work?
ST-LINK is a USB device and has to be connected to a PC host. It can be either embedded on ST boards or provided as standalone dongle. ST-LINK can support different debug protocols depending on ST-LINK hardware version and on its embedded firmware version: SWIM: debug protocol for STM8 microcontrollers.
Is St-Link Open Source?
Open source version of the STMicroelectronics STLINK Tools.
What kind of power does stlink V3 use?
STLINK-V3 can only supply the target with 5V power AND the 5V power appears to be connected to VCC of the target by default! You’ll may need to disconnect a jumper on one of the STLINK-V3SET boards to defeat this. 1. Full traditional JTAG using our TC2050-ARM2010 adapter TC2050-IDC 10-pin Plug-of-Nails ™ cables.
What kind of cable do I need for St-link / V2?
Both solutions for the ST-LINK/V2 are similar in that it requires an adapter and a cable, so it is up to you which one you will go for depending on your PCB needs. Here is the first solution: Connect the TC2050-ARM2010 to the ST-LINK/V2 and connect the TC2050-IDC cable to the adapter.
Can a stlink-v3set be used as a UART?
The STLINK-V3SET can provide a second Virtual COM port interface allowing the host PC to communicate with the target microcontroller through another UART (called bridge UART). Bridge UART signals, including optional RTS and CTS, are available on the adapter board only (MB1440).
How to connect tc2050-arm2010 to St-link / V2?
Here is the first solution: Connect the TC2050-ARM2010 to the ST-LINK/V2 and connect the TC2050-IDC cable to the adapter. Both “legged” and “no-leg” cables come in the standard 6″ length.The TC2050-IDC-NL will require the TC2050-CLIP if you want a hands-free solution while debugging.
https://www.youtube.com/watch?v=csSjUzbh1WE