Contents
How can I configure multiple networks with SonicWall?
Provide the subnet mask. Give a friendly comment for the interface. Enable the management if needed and click OK. By default, the access between the trusted zones is allowed. To deny access from LAN to the server zone, you need to edit the default access rule and set it to deny.
How can I configure a site to site VPN with SonicWall?
EXAMPLE: In the Example below, we are configuring the SonicWall Appliance as though we are at Site B (San Jose). Access the Address Groups Tab and click Add at the top of the screen to create new groups for the Translated Local Networks and the Translated Remote Networks.
What is the IP address for SonicWall x0?
The X0 interface on the SonicWall, by default, is configured with the IP 192.168.168.168 with netmask 255.255.255.0. In this scenario, we will be adding two more networks on X2 and X3 interfaces respectively. X2 network will contain the printers and X3 will contain the Servers.
Why is SonicWall unable to access hosts behind SonicWall firewall?
One of the most common reasons for not being able to access computers on the LAN/DMZ is when the default gateways on the PCs behind the firewall are not set to the SonicWall LAN/DMZ IP address.
How are wire mode rules applied in SonicWall?
Access rules are applied to the Wire Mode pair based on the direction of traffic between the source Zone and its Paired Interface Zone. For example, if the source Zone is WAN and the Paired Interface Zone is LAN, then WAN to LAN and LAN to WAN rules are applied, depending on the direction of the traffic.
How to use SonicWall tz-210 as a firewall?
I’ve inherited a Sonicwall TZ-210 (SonicOS Enhanced 5.5.20-3o) firewall running a multiple interface config: 1st Interface: Running LAN (data network) 2nd Interface: Running PBX network (voice network) I’ve disabled some NAT settings for the PBX server, and now the server (on X5) cannot communicate with the internet, nor is it reachable from X1.
How to define address objects in SonicWall enhanced OS?
With the Sonicwall Enhanced OS you can define Address Objects and Service objects to make management much simpler. First, make sure your host or server is listed as an Address Object under Network -> Address Objects. Then move on to Network -> Services to add your services you wish to route.